Table of Contents
Advertisement
HOW TO USE (Cont.)
DELAYED WASHING
This washing machine has a 0–24 hour delay start function which you can set to determine
the time when the washing program will finish.
NOTES:
This function is not available for the
when using this function, make sure the water taps are open, the drain hose is properly
installed and the washing load and detergent are properly prepared.
1.
Put your washing in the machine, loading items uniformly in the tub.
2.
Press the
3.
Select the required
4.
Press the
the
SET
button to select the desired time period (in hours) for the wash to finish.
5.
Select the water level, if necessary.
6.
Add any detergents.
7.
Close the washer lid and press the
8.
After setting the delay, the corresponding light will illuminate and all other lights
will be switched off about one minute later. From this time on until the delayed
time only the
9.
To check the delayed program, press the SET button: the program will be
indicated for 5 seconds. During these 5 seconds you can press the
button and set the water level.
10.
To cancel the delay, shut off the power.
11.
To change the delay time, first cancel the delay, then set it again.
ADDING DETERGENT TO A DELAYED WASH
When using the delayed wash, we recommend you do not add detergent directly to the
wash tub but follow the instructions below:
POWDER DETERGENT:
prefer to put it directly into the wash tub, wrap the powder in a small cloth.
LIQUID DETERGENT AND BLEACH:
the pulsator. Do not pour it directly into the tub as it may cause discolouration of
your washing.
FABRIC SOFTENER:
POWER ON/OFF
button.
PROGRAM
PROCESS
button until the Delay indicator light flashes, then press
POWER
and
SET
either put powder detergent into the detergent box or, if you
pour liquid detergent or bleach into the hole on
Refer to page 20
DELICATE
program. To avoid water leakage
and/or PROCESS.
START/PAUSE
buttons will response when pressed.
button.
WATER LEVEL
19
Advertisement
Table of Contents
