Sony VGF-CP1 Quick Start Manual page 2

Connecting
1
Attach the threaded portion of the
stand to the threaded hole at the
bottom left corner of the back of the
unit.
2
Connect the AC adapter plug to the
unit.
AC adapter
A ferrite core is supplied
with the U.K. model only.
Turning ON
For the customers purchasing the U.K. model
After connecting the power cord for the first time, the screen detailing the required user registration appears.
Please fill out the required contents and proceed to the following procedure.
1
Make sure the stand, power and remote control are ready for use by following the
steps in "Connecting" (this page).
This unit turns on after connecting the power cord.

Hint
Press  (POWER) to turn the power on when in standby mode.
3
Connect the power cord to the AC
adapter, then connect the power
cord plug to a wall outlet.
To wall
outlet
The power turns on and the start-up screen
appears.
Setting up the remote control
1
Remove the insulation sheet from
the remote control.
Turning OFF
To set to standby mode
"Standby Mode" reduces power consumption by deactivating the screen.

If you set [ System settings] - [Auto power on/off ] to [On] in the setting screen of this unit, the power will

automatically turn on or enter standby mode according to a surrounding ambient brightness. For details, see
"Settings Menu" on the Operating Instructions supplied with this unit.
1
Press  (POWER) on the remote control pointing at the remote control sensor of
this unit.
The STANDBY indicator lights up in orange and turns to standby mode.

Hint
This unit can also be set to standby mode by pressing  (POWER) on the back of this unit.
To turn off the power
The steps below show how to turn off the power to remove the AC adapter, etc.
1
Press  (POWER) on the back of this unit.
The STANDBY indicator lights up in orange and standby mode is set.
2
Press and hold  (POWER) on the back of this unit.
The New Info indicator blinks and turns off when the power turns off.
Note
You cannot turn off the power by the remote control.

Press and hold  (POWER) only when in standby mode. If you turn the power off from a mode other than standby mode,

stored data may be lost.
Ports
Front
 WLAN (wireless LAN) indicator
Lights up when the wireless LAN turns on.
 STANDBY indicator
Lights up in standby mode.
 New Info indicator
Blinks when receiving new information. Also
can be turned on as a light.
 Remote control sensor
Receives a signal from the remote control.