Acer X1230PK Series User Manual page 34

24
User Password
•
•
•
•
•
•
•
Administrator Password
You can enter "Administrator Password" when the "Enter
Administrator Password" or "Enter Password" dialogue box
displays.
•
•
If you forget your administrator password, do the following
to retrieve the administrator password:
•
•
VGA OUT Selecting "On" enables the function. The projector can output
(Standby) a VGA signal when it is in standby mode and the VGA IN (or
(for X1130PA/ VGA IN 1) and VGA OUT sockets are correctly connected to the
X1130PS/ devices.
X1230P/
X1230PA/
X1230PK/
X1230PS/X1237)
Press
Reset
parameters on all menus to the factory default settings.
Press to set up or change "User Password".
Use the numerical keys on the remote control to set the
password and press "MENU" to confirm.
To delete the digits, Press
Enter the password again when you see "Confirm
Password" displayed.
The password should be 4~8 digits in length.
If you select "Request password only after plugging
power cord", you are requested to input the password
every time the power cord is plugged.
If you select "Always request password while projector
turns on", you are requested to input the password every
time the projector is turned on.
Press to change "Administrator Password".
The factory default of "Administrator Password" is
"1234".
Enter the unique 6-digit "Universal Password" which is
printed on the Security Card that came with your
projector. This unique password will be accepted by the
projector no matter what the administrator password is.
If the Security Card is lost, please contact your local Acer
service center.
Enabling this function slightly increases the standby
power consumption.
after choosing "Yes" to return the display
.