Management - Acer H6500 Series User Manual

H. Position
•
(Horizontal
•
position)
V. Position
•
(Vertical position)
•
Frequency "Frequency" changes the projector's refresh rate to match the
frequency of your computer's graphics card. If you can see a vertical
flickering bar in the projected image, use this function to make the
necessary adjustments.
Tracking Synchronizes the signal timing of the projector with the graphics card.
If you experience an unstable or flickering image, use this function to
correct it.
HDMI Scan Info Adjust the overscan ratio of the HDMI image on screen.
•
•
•
Note: "H. Position", "V. Position", "Frequency" and "Tracking" functions
are not supported under HDMI or Video mode.
Note: "HDMI Scan Info" function is only supported under HDMI mode.

Management

ECO Mode Choose "On" to dim the projector lamp which will lower power
consumption, extend the lamp life and reduce noise. Choose "Off"
to return normal mode.
High Altitude Choose "On" to turn on High Altitude mode. Operate the fans at
full speed continuously to allow for proper high altitude cooling of
the projector.
Auto Shutdown The projector will automatically shutdown when there is no signal
input after the allocated time. (in minutes)
Turn Off Mode •
•
Press to move the image left.
Press to to move the image right.
Press to move the image down.
Press to move the image up.
Auto: Automatically adjust by information from player.
Underscan: Always no overscan on HDMI image.
Overscan: Always keep overscan on HDMI image.
Standard: Properly shuts down the projector after fan cooling.
Instant Resume: Resumes the system when the Power button is
pressed again within 2 minutes.
21