LED World HUEDA H-2819S Quick Start Manual

HUEDA™ RGBW RF Remote Control
Model: H-2819S
Before you begin, read all warnings and installation instructions and save for future use.

1. Product Introduction:

The HUEDA™ RGBW handheld remote controller can
control 4 different zones wirelessly and has 3 color
save buttons. You can choose any color through
color wheel. Color can be selected through the
color wheel. Requires 3 AAA ALKALINE batteries(not
included).

2. Buttons Instructions:

White channel: the 4th channel
4 zones: each zone can save
Running button/Speed button

3. Pair/Unpair Guide:

To Pair with HUEDA™ RF Controller, press the learning button on HUEDA™ RF Controller, and then on
HUEDA™ Remote Controller press the desired zone button and then change the color via color wheel on
Remote controller. Connected LED light will blink that confirms Pairing. To Unpair press the learning
button on HUEDA™ RF Controller for about 5 seconds, then Connected LED light will blink that confirms
Unpairing
4. Product Specications:
Operation Voltage
Operation Frequency
Dimensions
Transmitting Distance
1/2
Copyright © 2016 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
3 color or modes
Brightness: dim down
Color save button
(press and hold to save
desired color)
4.5V DC
434 MHZ / 868 MHz
48 x 140 x16mm (1.88 x 5.51 x 0.62 inch)
100 ft (30 meter)
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.0 02/01/16
Ÿ
Four zones/areas
Ÿ
Press-button RGB+W controller
Ÿ
Receivers work with WIFI-RF converter to be controlled by smart
phone device
Indicator: indicate the state of
remote control
W
Color wheel
ON/OFF of all zones
W+
S1 S2 S3
ledworldlighting.com ledworld.ca
Brightness: dim up
ww nw and cw mixed by RGB
Batteries (Back side)
|
1-800-387-4081