Advertisement
Fountain Components
Image
Fountain Water
Andra Fountain
Assembly & Installation - A fountain can be diffi cult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Fountain Information:
• This fountain holds approximately 1 gallon of water.
• This fountain uses a small fountain cover: FTNCOV-SM
• No refi ll device or submersible lights are suggested for this fountain
Pump Information:
OEMPF140 - 140 GPH Pump 6 FT cord length
Tools Required:
Bubble Level
Screwdriver
Component
Item Description
Quantity
Item #
Zen Too
FT-194A
Feature
FT-216B
Base
Fountain Set-Up:
Image
1
1
FT-216 Andra Fountain
Assembly Instructions
Pump Kit Parts List
Component
PK140 Pump
(use only large adapter)
#7 Stopper
Approx. 6" length of 1/2" black
non-kink tubing
Approx. 2" length of 5/8" clear vinyl
tubing
Approx. 2" length of 1/2" CPVC pipe
Hose Clamps
Proudly
MADE IN USA
Quantity
1
1
1
1
1
1
rev 3/30/2020
Advertisement
Table of Contents
Related Manuals for Campania International Andra FT-216
Summary of Contents for Campania International Andra FT-216
- Page 1 FT-216 Andra Fountain Assembly Instructions Fountain Information: • This fountain holds approximately 1 gallon of water. • This fountain uses a small fountain cover: FTNCOV-SM • No refi ll device or submersible lights are suggested for this fountain Pump Information: OEMPF140 - 140 GPH Pump 6 FT cord length Tools Required: Bubble Level...
- Page 2 FT-216 Andra Fountain Assembly Instructions Assemble your fountain on a level surface capable of holding a minimum of 100 lbs with an approximate 1/3 sq. ft. footprint (actual dimensions 7" x 7"). Step 1 - Position the basin (FT-216B) where the fountain is to be installed, ensuring that it is level. Step 2 - Assemble the pump kit: 2a - Using a hose clamp, attach the 1/2"...
- Page 3 Maintenance: Pump Care - The fountain relies heavily on the quality of the pump. A well-maintained pump can last several years. Step 1 - Fully submerge: Ensure the pump is fully submerged at all times to avoid damage. Step 2 - E nsure water level is sufficient: Check water levels regularly as water may evaporate over time, and periodically change water to avoid algae buildup.
Need help?
Do you have a question about the Andra FT-216 and is the answer not in the manual?
Questions and answers