Table of Contents
Advertisement
needed on any treaded hole in the bracket
with the bolts provided.
Water connections
-Use the same flex pipes you had on your
old tank water heater or replace them with
new ones if the old ones are rusted or
damaged. On the hot side (left side of the
unit!) as closest possible to the unit install
a Pressure relief valve.
Temperature relief valve is not
NOTE:
necessary or required because the
unit has a integrated, redundant over
temperature protection system.
-The pipe in the discharge part of the valve
has to be of a minimum ½ inch galvanized
or cooper pipe
-The discharge valve has to vent to the
exterior of the building
-The discharge line is not be allowed to
have treads on the end.
-The discharge line can not be run in an
upward direction
-The discharge line must terminate
between 6" and 24 inch above ground
level.
Gas Installation
The gas line is from the bottom of the unit:
Connect the gas unit thru hard line or a
approved flex hose not less then ½
"diameter. You can use your old flex hose
if is sufficient long and at of list ½"
diameter.
Warning:
Your line has to have a pressure of
minimum 0.33 PSI and the capacity
to move a sufficient quantity of gas to
produce 95.000 Btu.
Lengthy gas pipe with out step-
downs will not be able to supply the
necessary gas volume for the unit
In order that the unit to work you need to
install 2 Dcell batteries. (Not provided!)
Warning:
the batteries on installation. Incorrect
batteries installation will render the
unit inoperative.
The freezing device is not adjustable, do not
turn or disassemble. Only a authorized
technician can perform maintenance on the
anti-freezing device
Maintenance
The unit is virtual maintenance free with the
exception of the de-scaling every 1 to 3
years based of the PH of the local water
supply. The harder is the water, more often
the de-scaling has to be done. Ask a local
professional for advice in regard to the
composition of the water. Your local Water
Company or your local Gas Company can
help you with the necessary data.
De-scaling involve harsh chemicals and
specialized tools and can only be done by a
professional.
6
Follow the polarity of
Advertisement
Table of Contents
