Table of Contents
Advertisement
PICTURE PATTERN
When "Left" or "Right" is selected in MUTI PICTURE, this selects the size of the picture.
AUTO: Shows 2 screens based on the INPUT RESOLUTION and EXPANSION settings for the priority (adjustable)
screen selected in MULTI PICTURE.
CENTER: Splits 2 screens divided evenly from the center.
When "Main" or "Sub" is selected in MUTI PICTURE, this selects the position of the sub screen.
LEFT: The sub screen's start position is bottom-left side of the screen.
RIGHT: The sub screen's start position is bottom-right side of the screen.
PICTURE SIZE
Selects SMALL, MIDDLE or LARGE for the size of the sub-picture used in Picture in Picture mode.
PICTURE POSITION
Determines where the sub screen appears on the screen.
Touch the SELECT key to enter the PICTURE POSITION mode (Figure 1).
Using LEFT, RIGHT, UP and DOWN keys controls the horizontal and vertical position of the sub screen within the
boundaries of the side where the sub screen is located (Figure 2).
Figure 1
Figure 2
OFF TIMER
The monitor will automatically power off after a period of time has passed, which you can set.
Before powering off, a message will appear on the screen asking if you want to delay the turn off time by 60 minutes.
Touch any OSD key to delay the power-down time.
POWER SAVE TIMER
POWER SAVE TIMER allows the monitor to turn off automatically after 2 consecutive hours in power save mode.
LED BRIGHTNESS
Adjusts the blue LED brightness.
DDC/CI
This function turns the DDC/CI function ON or OFF.
USB FUNCTIONALITY
Selects how power through the USB type A port and USB type C port is enabled in relation to the Monitor's power
status.
AUTO: Power is supplied to the USB downstream port depending on the monitor's power condition.
ON: Power is always supplied to the USB downstream port even when the monitor is in power save mode or
power OFF.
OFF: All USB functions (include USB Type-C video signal) are disabled.
NOTE: Actual power consumption depends on the connected USB device even when the monitor's power is off.
USB SELECTION
Change the USB upstream input (USB or USB-C) associated with the current display input. When connecting a
computer to each of the upstream ports, the monitor's USB downstream ports can be used by selecting this setting for
the current input signal.
You can change the active display and upstream USB port combination by using the Input key (see
page
14).
When using only one upstream port, the connected upstream port is used by default.
NOTE: To avoid data loss, before changing USB upstream ports, ensure that no USB storage devices are in use by
the operating system of the computer attached to the USB upstream port.
FACTORY PRESET
Selecting Factory Preset allows you to reset all OSD control settings back to the factory settings except Language,
OSD Lock Out and items in Multi Display tag. Individual settings can be reset by touching the "
/RESET" key.
English-19
Advertisement
Table of Contents
