Table of Contents
Advertisement
13.8 Starting the programme
Note: If you want to change the time
until the programme ends, set the
"Ready in" time first.
Press Start/Reload.
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: End.
13.9 Changing the activated
"Ready in" time
If you have set and activated a
"Ready in" time for a delayed pro-
gramme start, you can change the
"Ready in" time again before the pro-
gramme starts.
Requirements
¡ The programme is set.
→ "Setting a programme", Page 29
¡ The "Ready in" time is set and ac-
tivated.
→ "Buttons", Page 23
Press Start/Reload.
1.
The activated "Ready in" time is
paused.
Press Finish in repeatedly until the
2.
display indicates the desired
"Ready in" time.
Press Start/Reload.
3.
The changed "Ready in" time is ac-
tivated.
13.10 Adding laundry
Press Start/Reload.
1.
The appliance pauses.
appears, it is not pos-
Note: If
sible to add laundry.
When
goes out, it is possible to
add laundry.
Open the appliance door.
2.
Add or remove laundry.
3.
Close the appliance door.
4.
Press Start/Reload.
5.
13.11 Cancelling the pro-
gramme
Press Start/Reload.
1.
Open the appliance door.
2.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→ "Programmes", Page 24
Remove the laundry → Page 31.
3.
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Start the Spin programme or se-
1.
lect a suitable programme for
draining.
→ "Programmes", Page 24
Press Start/Reload.
2.
13.13 Unloading the laundry
Open the appliance door.
1.
Remove the laundry.
2.
Basic operation en
31
Advertisement
Table of Contents
