Table of Contents
Advertisement
5-3-2-2 Memory Addressing
Parameter
Memory Addressing
NUMA nodes per socket
Memory inerleaving
Memory interleaving size
1TB remap
DRAM map inversion
Location of private memory
regions
Description
Specifies the number of desired NUMA nodes per socket.
Options available: Auto, NPS0, NPS1, NPS2, NPS4. Default setting is NPS4.
Enable/Disable the Memory interleaving feature.
Options available: Auto/Disabled. Default setting is Auto.
Controls the memory interleaving size. This determines the starting address of
the interleave (bit 8, 9, 10 or 11).
Options available: Auto, 256Bytes, 512Bytes, 1KB, 2KB. Default setting is Auto.
Enable/Disable to remap DRAM out of the space just below the 1TB boundary.
The ability to remap depends on DRAM configuration, NPS, and interleaving
selection, and may not always be possible.
Options available: Auto, Do not remap, Attempt to remap.
Default setting is Auto.
Enable/Disable the DRAM map inversion function.
Options available: Auto, Enabled, Disabled. Default setting is Auto.
Control whether or not the rpivate memory regions (PSP, SMU, and CC6) are
at the top of DRAM or distributed. Note that distributed requires memory on
all dies. Note that it will always be at the top of DRAM if some dies don't have
memory regardless of this.
Options available: Auto, Distributed, Consolidated. Default setting is Auto.
- 63 -
BIOS Setup
Advertisement
Table of Contents
