Specifications - Toro 5 Operator's Manual

Specifications

Reel Construction: Fairway reels. All welded. 5, 7
or 11 blades.
Recommended Height Of Cut Range:
5 Blade – 1" to 1-3/4" (25–44 mm)
7 Blade – 1/2" to 1" (13–25 mm)
11 Blade – 3/8" to 3/4" (10–19 mm)
Note: Use bedknife Part No. 93-9774 for
heights-of-cut below 1/2" (13 mm).
Reel Diameter: 7 in. (178 mm)
Power Attachment: Reel motors feature quick
disconnect for removal or installation onto cutting
unit. Cutting units can be driven from either end.
Height–of–cut & Roller Adjustment: Height-of-cut
adjustment is made at the rear roller with quick
locating pin and/or threaded micro–adjustment. Front
roller position is adjustable to set cutting unit attitude.
Bedknife And Bedbar Adjustment: Single point
adjustment (SPA) mechanism.
Selected Clip Control: The Reelmaster 5500
Traction Unit is equipped with manually adjustable
reel speeds which control selected clip.
Note: Refer to Traction Unit Operator's
Manual for proper set–up procedure.
Automatic Clip Control: The Reelmaster 6000
Series Traction Unit is equipped with an electronic
controller which is programmed to achieve automatic
clip control. As the traction unit speed varies, the
controller will automatically adjust the hydraulic flow
to the reel motors to vary reel speed and maintain
proper clip. For proper clip, the controller needs to
know what cutting units are installed (5, 7 or 11
blade) and the height-of-cut.
Note: Refer to Traction Unit Operator's
Manual for proper set–up procedure.
4
Rollers: Front roller is a 3" (76 mm) diameter cast
Wiehle roller. Rear roller is a 3" (76 mm) diameter
steel full roller. Both rollers use heavy duty ball
bearings with two conventional single lip seals and a
Toro labyrinth seal to provide four sealing surfaces to
protect the bearings.
Optional Equipment
Dethatching Cutting Unit
Grass Basket Kit
High Torque Reel Motor
Wiehle Roller Scraper
Rear Roller Scraper Kit
RM6000 Shoulder Wiehle Roller
RM5500 Shoulder Wiehle Roller Part No. 100-9911
RM6000 Shoulder Wiehle Scraper Part No. 99-8670
RM5500 Shoulder Wiehle Scraper Part No. 100-9913
Low Height-of-Cut Bedknife*
Gauge Bar Assembly
Angle Indicator
Backlapping Brush Assembly
Bedknife Screw Tool
Cutting Unit Tool Kit
Reel Drive Tool
* For height-of-cut below 1/2" (13 mm)
Supplied with tractor
Model No. 03871
Model No. 03882
Part No. 98-2448
Part No. 100-9908
Part No. 100-9920
Part No. 99-8675
Part No. 93-9774
Part No. 98-1852
Part No. 99-3503
Part No. TOR299100
Part No. TOR510880
Part No. TOR4070
Part No. TOR4074