Shark Rocket ZS351Q Series Owner's Manual page 6

MAINTENANCE
CHECKING FOR BLOCKAGES
CHECK HANDHELD
Remove the wand from the handheld vacuum and
check all dust cup intake openings.
CHECK CLEANER HEAD
Detach the wand, then use the edge of a coin to open
the three locks on the bottom of the cleaner head.
Remove the cover, then tilt back the neck of the
cleaner head and check the opening for blockages.
Replace cover, pressing down firmly on all sides,
including along the front, before turning locks
clockwise to close.
s h a r kc l e a n . c o m
CHECK WAND
Detach the wand and check it for blockages.
MAINTENANCE
CLEANER HEAD MAINTENANCE
Zero-M™ Technology actively removes hair wrap from your brushroll while you vacuum. If you run over
a hard or sharp object or notice a noise change while vacuuming, check for blockages or objects caught
in the brushroll.
NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow Zero-M technology to remove it for you.
We recommend using High Pile Carpet Mode on a bare floor surface or lower pile carpet or area rug. Run the vacuum back
and forth to allow hair to make its way to the dust cup. If some fibers remain wrapped around the brushroll after continued
use, carefully remove the debris from the brushroll.
1. Using a coin, turn locks counterclockwise to
open, then lift off cover to access Brushroll.
2. Clear airway of blockages.
3. Replace cover, pressing down firmly on all sides,
including along the front, before turning locks
clockwise to close.
s h a r kc l e a n . c o m