Acer Power SD Service Manual page 63

BIOS Messages
IDE Drive 0 Error
IDE Drive 1 Error
IDE Drive 2 Error
IDE Drive 3 Error
IRQ Setting Error
Expansion ROM Allocation Fail
I/O Resource Conflict(s)
Memory Resource Conflict(s)
PCI Device Error
PS/2 Pointing Device Interface Error
PS/2 Pointing Device Error
DMI Table Was Destroyed
Press CTRL + ALT + DEL key to enter Setup or F1
key to continue
Press ESC to turn off NMI, or any key to reboot
Insert system diskette and press ENTER key to
reboot
58
Action/FRU
1. Enter BIOS Setup and load the default settings.
2. Check IDE drive jumper.
3. IDE hard disk drive power.
4. IDE hard disk drive cable/connection.
5. IDE hard disk drive.
1. Load default settings in Setup.
2. Enter BIOS Setup and set the Reset Resource
Assignments of the PnP/PCI Options to Yes,
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed, then reboot the system
1. Load default settings in Setup.
2. Enter BIOS Setup and set the Reset Resource
Assignments of the PnP/PCI Options to Yes,
then reboot the system.
3. Remove all adapter cards that are NOT factory-
installed, then reboot the system.
1. Re-connect PS/2 keyboard and mouse.
2. Enter BIOS Setup and load the default settings.
3. PS/2 mouse
4. PS/2 keyboard
5. System board
1. Flash BIOS
1. Press CTRL + ALT + DEL to enter Setup and
reconfigure the system.
1. Press ESC to reject NMI error or press any other key
to reboot the system.
1. Insert a bootable disk into the floppy disk drive or
remove this disk if a hard disk is installed.
Chapter 4