Advertisement
SELF-PRIMING PORT ABLE ELECTRIC PUMP
SELF-PRIMING PORT
SELF-PRIMING PORT
SELF-PRIMING PORT
SELF-PRIMING PORT
1.
Unpack all boxes and check for damaged equipment.
2.
Assemble cart for vacuum as instructions in box indicate.
3.
Place motor on cart and bolt down with supplied hardware.
4.
With thread sealing compound in pump motor box (thread sealer not supplied),
attach discharge fitting on pump discharge. Do not over tighten.
5.
With thread sealing compound attach pump suction to suction side of electric
pump. Suction assembly has line to show direction of flow for proper installation.
If installed correctly the priming valve will be vertical with the ground. Do not over
tighten.
6.
Note: This unit is not supplied with a ground fault interrupt. A ground fault interrupt
is needed for safe operation of this unit. Do not plug pump into an outlet without
installed ground fault interrupt.
If you have any questions on the assembly or operation of this pump cart contact
customer service at 1-800-437-8072.
ASSEMBL
ASSEMBL
Y INSTRUCTIONS
Y INSTRUCTIONS
ASSEMBL Y INSTRUCTIONS
Y INSTRUCTIONS
ASSEMBL
ASSEMBL
Y INSTRUCTIONS
ABLE ELECTRIC PUMP
ABLE ELECTRIC PUMP
ABLE ELECTRIC PUMP
ABLE ELECTRIC PUMP
Advertisement
