Table of Contents
Advertisement
EXTENSION CORD
Because of potential safety hazards under certain conditions, it is strongly recommended that you do
not use an extension cord with this appliance. However, if you must use an extension cord, it is
absolutely necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord
having a grounding type plug and outlet and that the electrical rating of the cord be 115 volts and at
least 10 amperes.
INSTALLING THE DOOR HANDLE
This beverage cooler includes a stainless steel handle that is not required to operate the unit. To install
the handle, follow the instructions below:
1.
Remove the door gasket on the side you wish to install the
handle - you can see two designated holes for handle
installation. The gasket is easily displaced by hand; no
tools are necessary.
2.
Install the handle tightly as shown with two screws and
flat washers provided. (DO NOT over-tighten as this will
cause damage to the handle and stainless steel door
frame).
3.
Replace the door gasket to its original position.
REVERSING THE DOOR SWING (if desired)
5. Take out the hinge cover
and handle hole caps
Hinge
cover
12. Finished
4. Take out the caps
on the holes
Handle
Handle
hole caps
hole caps
7. Take off
6. Remove
the handle.
screws
11. Assemble the upper
door hinge and screws to
the other side.
10. Hold tight and set
glass door downwards
on the lower door hinge
9. Assemble the lower
door hinge to the other
side, and assemble the
screws
6
Gasket
Flat Washer
Handle
Screw
Door Fra
1. Remove the
screws and hinge at
the same time.
2. Hold tight and pull,
the door upwards
and off carefully
3. Remove the screws
and lower door hinge
Hinge
cover
8. Assemble the hinge cover
and handle hole caps.
Advertisement
Table of Contents
