Advertisement
Troubleshooting guide.
Problem
Sensor does not show on
gauge readout.
BIM will not light up at all.
Sensor does not show on
gauge readout.
BIM display is scanning
"J", "F", "C"
Sensor does not show on
gauge readout.
BIM has a steady dot lit
BIM display shows ":"
DAKOTA DIGITAL offers complete service and repair of its product line. In addition, technical
consultation is available to help you work through any questions or problems you may be having installing
one of our products. Please read through the Troubleshooting Guide. There, you will find the solution to
most problems.
Should you ever need to send the unit back for repairs, please call our technical support line, (605)
332-6513, to request a Return Merchandise Authorization number. Package the product in a good
quality box along with plenty of packing material. Ship the product by UPS or insured Parcel Post. Be sure
to include the RMA number on the package, and include a complete description of the problem with RMA
number, your full name and address (street address preferred), and a telephone number where you can be
reached during the day. Any returns for warranty work must include a copy of the dated sales receipt from
your place of purchase. Send no money. We will bill you after repair.
DAKOTA DIGITAL warrants to the ORIGINAL PURCHASER of this product that should it, under
normal use and condition, be proven defective in material or workmanship for the lifetime of the original
vehicle it was installed in, such defect(s) will be repaired or replaced at Dakota Digital's option.
This warranty does not cover nor extend to damage to the vehicle's systems, and does not cover
removal or reinstallation of the product. This Warranty does not apply to any product or part thereof which
in the opinion of the Company has been damaged through alteration, improper installation, mishandling,
misuse, neglect, or accident.
This Warranty is in lieu of all other expressed warranties or liabilities. Any implied warranties,
including any implied warranty of merchantability, shall be limited to the duration of this written warranty. No
person or representative is authorized to assume, for Dakota Digital, any liability other than expressed
herein in connection with the sale of this product.
Possible cause
PWR terminal does not have power.
GND terminal does not have a good
ground.
Module is damaged.
OBD-II Interface cable is not connected. Connect the supplied OBD-II cable between the BIM unit and
The vehicle bus is not compatible.
Interface cable is not connected.
Interface cable is loose.
On VHX systems, the BIM display
for this channel is disabled.
Another BIM is set with the same
channel IDs.
Data cable is damaged.
Another module on the bus is damaged Inspect other modules on the data bus.
or connected improperly.
SERVICE AND REPAIR
Dakota Digital Limited Lifetime Warranty
Solution
Connect to a location that has power.
Connect to a different ground location.
Return for service. (see instructions)
the vehicle diagnostic plug.
Vehicles using the ISO 9141-2 protocol are not compatible with the BIM-01.
This includes some Chrysler and many import vehicles.
Connect the supplied 3.5mm data cable between the BIM unit and
the gauge control box.
Make sure both ends of the cable are seated in securely.
Follow instructions in VHX manual to enable the BIM display screen.
Test module works when connected to control box alone. Change ID's
on one of the modules so each module uses unique IDs.
Inspect and replace 3.5mm data cable.
_
_
_
MAN #650341D
Advertisement
