Advertisement
Display data usage
The RPM, speed, and engine temperature can each be used in place of connections to the gauge control unit. These
are individually selectable in the display system gauge setup menus.
The transmission gear position will be displayed in the message center if it is available. This will automatically be
displayed whenever the gear changes. If a GSS gear position sender is connected the GSS will override the BIM-01-1
data.
The malfunction indicator lamp (MIL) or service engine soon indicator will be activated from the data bus when there is
an engine code set. This will not turn on the indicator for a lamp test function when the key is on, but the engine is not
running. This indicator can be enable or disabled in the BIM-01 setup. Some gauge features require a minimum
software revision or higher to be supported:
VHX
VFD3
VFD3X
The intake air temp, transmission temp, and ambient air temp will be displayed in the message center.
Using speed from the BIM-01-1
•
Hold the SW1 switch from the gauge system control box while turning the key on. The message display
should show SETUP.
•
Release SW1. The message display should show SPEED.
•
Press and hold SW1. The message display should show SENDER. Release SW1.
•
Press and release SW1 until BUS is displayed.
•
Press and hold SW1 until DONE is displayed.
Using rpm from the BIM-01-1
•
Hold the SW1 switch from the gauge system control box while turning the key on. The message display
should show SETUP.
•
Release SW1. Press and release SW1 until TACH is displayed.
•
Press and hold SW1. The message display should show T CAL or ENGINE. Release SW1.
•
Press and release SW1 until BUS is displayed.
•
Press and hold SW1 until DONE is displayed.
Using engine temperature from the BIM-01-1
•
Hold the SW1 switch from the gauge system control box while turning the key on. The message display
should show SETUP.
•
Release SW1. Press and release SW1 until WATER is displayed.
•
Press and hold SW1. The message display should show SENDER. Release SW1.
•
Press and release SW1 until BUS F or BUS C is displayed depending on your unit choice.
•
Press and hold SW1 until DONE is displayed.
Using oil pressure from the BIM-01-1 (if available)
•
Hold the SW1 switch from the gauge system control box while turning the key on. The message display
should show SETUP.
•
Release SW1. Press and release SW1 until OIL is displayed.
•
Press and hold SW1. The message display should show SENDER. Release SW1.
•
Press and release SW1 until BUS is displayed.
•
Press and hold SW1 until DONE is displayed.
Using fuel level from the BIM-01-1 (if available)
•
Hold the SW1 switch from the gauge system control box while turning the key on. The message display
should show SETUP.
•
Release SW1. Press and release SW1 until FUEL is displayed.
•
Press and hold SW1. The message display should show SENDER. Release SW1.
•
Press and release SW1 until BUS is displayed.
•
Press and hold SW1 until DONE is displayed.
Engine Indicator
VX03
SE45
SE54
Oil Pressure & Fuel Level
VX04
SE47
SE55
MAN #650341D
Advertisement
