AEG SCE81826TC User Manual page 15

Problem
The lamp does not work.
The compressor operates
continually.
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the "FROSTMAT-
IC" or "COOLMATIC", or af-
ter changing the tempera-
ture.
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig-
erator.
Possible cause
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The "FROSTMATIC" or
"COOLMATIC" is switch-
ed on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
This is normal, no error has
occurred.
During the automatic de-
frosting process, frost
melts on the rear plate.
Food products prevent the
water to flow into the wa-
ter collector.
The water outlet is clog-
ged.
ENGLISH
Solution
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "FROSTMATIC func-
tion" or "COOLMATIC func-
tion".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" .
The compressor starts after a
period of time.
This is correct.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
15