Campania International Corsini FT-171A Assembly Instructions

Fountain Components
Image
Assembly & Installation - A fountain can be difficult to install without knowing and understanding the steps involved. To ensure your fountain is
installed properly, please read our instructions and tips before you begin.
Step 1 - Seek Professional Help: Check if professional installation is recommended for your fountain.
Step 2 - Check Foundation: Place your fountain on a level surface. It is recommended to place your fountain on concrete or a hard packed
gravel pad. If the base is level but some components seem off, rotate components or use wedges to level them.
Step 3 - Create a Drip Loop: To prevent water from dripping down the cord and damaging the electrical socket, create a drip loop by allowing
the pump power cord to fall below the wall outlet.
Step 4 - Use a GFCI Outlet: Use only a GFCI outlet when running a fountain.
Fountain Information:
• This fountain holds approximately 5-10 gallons of water.
• This fountain uses a large fountain cover: FTNCOV-LG
• Compatible with Refill #10 Device
(A different style stopper may be requested for this part)
Pump Information:
OEMPF140 - 140 GPH Pump 6 FT cord length
Tools Required:
Bubble Level
Screwdriver
Component
Item Description Quantity
Item #
Corsini Wall
Fountain - FT-171A
Water Feature
Lion Wall
Fountain - FT-165B
Pump House
Fountain Set-Up:
FT-171 Corsini Wall Fountain
Image
1
1
Assembly Instructions
Pump Kit Parts List
Component
PK140 Pump
(use only large adapter)
#10 Stopper
Approx. 6" length of 1/2" black
non-kink tubing
Approx. 2" length of 5/8" clear vinyl
tubing
Hose Clamps
Proudly
MADE IN USA
Quantity
1
1
1
1
1
rev 3/30/2020