Introduction & Warranty - V-TAC VT-6072 Installation Instruction

INTRODUCTION & WARRANTY
Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these
instructions carefully before starting the installing and keep this manual handy for future reference. If you
have any another query, please contact our dealer or local vendor from whom you have purchased the
product. They are trained and ready to serve you at the best. The warranty is valid for 3 years from the date
of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and
tear. The company gives no warranty against damage to any surface due to incorrect removal and installation
of the product. The products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a
day would void the warranty. This product is warranted for manufacturing defects only. The LED tube can be
used in hotels, offices, factories, conference rooms, meeting rooms, commercial complexes, residential
buildings, schools, colleges, universities, hospitals, etc.
WARNINGS!
• Installation should only be done by a certified electrician
• Operation environment temperature: from -20°C to +45°C
• Do not use DC electricity
• Do not use with electronic ballasts.
• Do not modify the fitting to be used with the LED Tube.
• V-TAC LED Tubes are NOT designed to be used in emergency operations.
• It is recommended to power the product directly, without electrical ballast. If the components are powered
through ballast, we cannot guarantee their long-term durability, therefore the warranty will be void.
Installation (New Fitting/Electronic Ballast replacement)
• Installation should only be done by a certified electrician
• Switch Off the power.
• Remove the fluorescent tube and starter.
• Bypass/rewire the circuit as per guidelines
and the wiring diagram.
• Insert V-TAC LED Tube.
• Switch On the power to test the light.
Installation & Replacement of Fluorescent Lamp(Single Magnetic Ballast Ciruit)
• Installation should only be done by a
certified electrician.
• Please refer to the wiring diagram for replacing
fluorescent tube on a single magnetic ballast circuit
with V-TAC LED Tube.
1. Switch off the power
LED
4. Insert LED T8 starter
EN EN INSTALLATION INSTRUCTION
INSTALLATION INSTRUCTION
2. Remove the existing
fluorescent lamp
5. Insert V-TAC LED Tube
PACKING:
• LED Tube (1PC)
• Instruction Manual (1PC)
• Dummy Starer (1PC)
Wiring Diagram
(L)
V-TAC
INPUT
(N)
Left
Single Side Power Only
Wiring Diagram
V-TAC
Left
INPUT
Inductance Ballast
AC:220-240V
3. Remove the existing
6. Switch ON the power
LED TUBE
LED Starter
LED TUBE
50Hz
fluorescent starter
Right
Right