Table of Contents
Advertisement
20. Do not use power tools in damp or wet
location, or expose them to rain. Keep work
area well lighted.
21. Do not leave a connected tool unattended.
When not in use, disconnect tool from air
source.
22. Shut off air supply and discharge any residual
pressure from tool before removing hose,
making adjustments, changing accessories,
or storing tool.
23. Make sure tool is switched off, and your finger
off the trigger, before connecting to air supply.
24. Remove adjusting keys and wrenches before
turning on tool.
25. Keep visitors a safe distance from the work
area. Keep children away.
26. Give your work undivided attention. Looking
around, carrying on a conversation and
"horse-play" are careless acts that can result
in serious injury.
27. Do not force a tool or attachment to do a job
for which it was not designed. The right tool
will do the job better and more safely.
28. Repetitive
motions
constant vibration can be harmful to hands
and arms. Take frequent breaks and relax
hands during extended operation. Change
posture to avoid discomfort or fatigue.
29. Compressed air can be harmful if directed
toward sensitive areas of the body, and may
propel small particles caught in the air stream.
Exercise proper caution.
30. Use
only
recommended
improper accessories may be hazardous.
31. Maintain tools with care. Keep air tool clean
and oiled for best and safest performance.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in serious, or even
fatal, injury.
This means that if precautions are not heeded, it may result in minor injury and/or
possible tool damage.
and/or
exposure
accessories;
32. Do not use combustible gases, carbon
dioxide, oxygen or any bottled gas as an air
source for the tool. These can present risk of
explosion and serious injury.
33. Do not lubricate the tool with combustible
liquids, such as kerosene, diesel or jet fuel.
34. Do not dispose of this tool with normal
household waste. Never dispose of the air tool
into fire.
Specific warnings for Chipping
Hammers
35. This chipping hammer is designed and
intended for use by properly trained and
experienced personnel only. If you are not
familiar with the proper and safe operation of
a chipping hammer, do not use until proper
training and knowledge have been obtained.
36. Make sure chisel has appropriate shank with
oval collar and dimensions for this chipping
hammer.
37. Always secure tool in retainer, and place end
of tool against workpiece before turning on
hammer.
38. Disconnect machine from air supply before
to
changing tooling.
39. Retainer must be properly installed with coil
spring
operation.
40. Always grip chipping hammer firmly with both
hands.
41. The inserted tool can become hot during
operation and cause burns if touched. Allow
tool to cool before attempting removal or
maintenance.
to
prevent
tool
ejection
during
JET
3
Advertisement
Table of Contents
