Troubleshooting - Rankam Member's Mark GR2298906-MM-01 Assembly Instructions & User Manual

Troubleshooting

Problem
Burner Will Not Light
Fire at Control Knob
Yellow Flame at Burner
Flame Blows Out on
"LOW"
Burner Does not Get
Hot Enough
Possible Cause
1. LP cylinder fuel is used
up.
2. Electrode tip not in
proper position.
3. Burner may not be
properly seated.
4. Burner may be
obstructed.
5. Cylinder valve may be
closed.
6. Regulator is not
properly seated on
cylinder valve.
1. Burner is improperly
seated on control valve.
2. Gas connections may
be loose.
3. Burner holes may be
obstructed.
1. Burner is obstructed.
1. Burner holes may be
obstructed.
2. Grill is not sufficiently
preheated.
3. Burner is improperly
seated on control valve.
1. Flow control device has
been activated in
regulator.
Prevention / Solution
1. Change a new, full LP cylinder.
2. Tip of electrode should be
pointing toward gas port opening
on burner. The distance should
be 1/8" to 1/4". Adjust if
necessary.
3. Refer to the section of "To
Reinstall The Main Burners" on
pg. 31 to reinstall the burner
properly.
4. Refer to the section of "Burner
Cleaning" on pg. 30 to clean the
burner.
5. Check then open the cylinder
valve.
6. Refer to the section of
"Connection Procedures" on pg.
6 to reinstall the regulator
properly.
1. Refer to the section of "To
Reinstall The Main Burners" on
pg. 31 to reinstall burner properly.
2. Refer to the section of "Leak
Check" on pg. 23-24 to check
and tighten all connections.
3. Refer to the section of "Burner
Cleaning" on pg. 30 to clean the
burner.
Refer to the section of "Burner
1.
Cleaning" on pg. 30 to clean the
burner.
1. Refer to the section of "Burner
Cleaning" on pg. 30 to clean the
burner.
2. Preheat the grill for sufficient
time.
3. Refer to the section of "To
Reinstall The Main Burners" on
pg. 31 to reinstall burner properly.
1. Reset the regulator. Turn off all
burners and close the LP tank
valve. Disconnect the regulator
from the LP tank and wait for one
minute. Reconnect the regulator
to the LP tank and slowly open
the LP tank valve until the valve is
26 | P a g e