Main - Acer Extensa 4630G Service Manual

Main

The Main screen allows the user to set the system time and date as well as enable and disable boot option
and recovery.
Information Main
System Time
System Date
Total Memory
Video Memory
Quick Boot
Network Boot
F12 Boot Menu
D2D Recovery
SATA Mode
↑↓
F1 Help
←→
ESC Exit
NOTE: The screen above is for your reference only. Actual values may differ.
The table below describes the parameters in this screen. Settings in boldface are the default and suggested
parameter settings.
Parameter
System Time Sets the system time. The hours are displayed with 24-
hour format.
System Date Sets the system date.
Total Memory This field reports the memory size of the system.
Memory size is fixed to 3017 MB.
Video Memory Shows the video memory size. VGA Memory size=32 MB
Quick Boot Allows startup to skip certain tests while booting,
decreasing the time needed to boot the system.
Network Boot Enables, disables the system boot from LAN (remote
server).
F12 Boot Menu Enables, disables Boot Menu during POST.
D2D Recovery Enables, disables D2D Recovery function. The function
allows the user to create a hidden partition on hard disc
drive to store operation system and restore the system
to factory defaults.
SATA Mode Control the mode in which the SATA controller should
operate.
NOTE: The sub-items under each device will not be shown if the device control is set to disable or auto. This is
because the user is not allowed to control the settings in these cases.
Chapter 2
InsydeH20 Setup Utility
Advanced Security
[13:04:04]
[06/04/2008]
4095 MB
[256MB]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[AHCI]
Select Item F5/F6
Select Menu Enter
Description
Power Boot Exit
Item Specific Help
This is the help for the
hour field. Valid range
is from 0 to 23.
INCREASE/REDUCE : F5/F6
Change Values
Select SubMenu
Rev. 3.5
F9 Setup Default
F10 Save and Exit
Format/Option
Format: HH:MM:SS
(hour:minute:second)
Format MM/DD/YYYY
(month/day/year)
N/A
N/A
Option: Enabled or Disabled
Option: Enabled or Disabled
Option: Enabled or Enabled
Option: Enabled or Disabled
Option: AHCI or IDE Mode
27