Download Print this page
Yaber YA10 User Manual

Yaber YA10 User Manual

Car battery jump starter

Advertisement

Quick Links

User Manual
Car Battery Jump Starter
support@yaberauto.com

Advertisement

loading

Summary of Contents for Yaber YA10

  • Page 1 User Manual Car Battery Jump Starter support@yaberauto.com...
  • Page 2: Package Content

    support@ibuture.com support@yaberauto.com Package Content 1 x Jump Starter 1 x Smart Jumper Cables User Manual Car Battery Jump Starter support@yaberauto.com 1 x Type C Cable 1 x User Manual...
  • Page 3 Introduction Thank you for purchasing YABER YA10 car jump starter. Please read the user manual carefully before you start to use the product. Key Features ★A Powerful Jump Starter: YABER Car Jump Starter can jump start 12V cars, SUV, truck or van (6.5L gasoline or 5.0L diesel engine) in seconds up to 30 times.
  • Page 4: Know Your Product

    support@yaberauto.com Know Your Product ⑨ ⑦ ⑥ ⑨ ① ② ③ ④ ⑤ ① Jump Starting Port ⑥ Power Switch ② LED Flashlight ⑦ Battery Indicator ③ QC3.0 USB Output ⑨ Compass ④ 5V/2.1A USB Output ⑨ Safety Hammer ⑤ TYPE C Input Powerful circuit protection system - Smart Clamps ①...
  • Page 5: Getting Started

    support@yaberauto.com Getting Started Charging your Jump Starter 1. Please use a 5V2A/9V2A/12V1.5A adapter to charge the product.(Type C cable is included, adapter is not included) 2. Using a 5V/2A adaptor, it will take approximately 4 hours to fully charge the unit. In order to extend the battery life it is recommended to fully charge (adapter is not included)...
  • Page 6 support@yaberauto.com Start your Car 1.Insert the plug of the smart clip complete- ly into the jump starter, the green and red lights flash alternately. 2.Correctly clip the red and black clamps to the electrodes of the car battery (red to positive and black to negative)(The green light stays on) 3.Start the vehicle.
  • Page 7 support@yaberauto.com 1.battery clamp is reversely connected --- check whether the clip is reversely connected The green light is always on 2.The clamp is short-circuited ---check whether two clamps together connect or connect both cable clamps to the same piece of metal Back change protection, the voltage of the car battery is higher than 12.6V The red light flashes slowly...
  • Page 8 Q: What kind of adapter should I use? A: You can use the charger of your phone or tablet.. Q: How long time to full charge the YABER YA10 jump starter? A: About 4 hours through the 5V2A AC adapter.
  • Page 9: Warranty

    support@yaberauto.com Care and Maintenance 1. DO NOT put the product under direct sunlight or hot areas. 2. DO NOT drop or knock your car jump starter. 3. DO NOT disassemble the equipment, it may cause damage. 4. DO NOT use chemicals or detergents to clean the product. 5.