Table of Contents
Advertisement
Replacing the system board
Attention
1
Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the computer.
2
Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently
lay it down so that the screen is against the surface and the computer cover is facing up.
3
Remove the computer stand. For details, see
4
Remove the computer cover. For details, see
5
Remove the system board shield. For details, see
6
Remove the VESA mount bracket. For details, see
7
Remove the heat sink. For details, see
8
Remove the memory module. For details, see
9
Remove the card reader. For details, see
10
Remove the M.2 storage drive. For details, see
11
Remove the serial connector module. For details, see
12
Remove the Wi-Fi card. For details, see
13
Remove the microprocessor. For details, see
14
Record the cable routing and cable connections, and then disconnect all cables from the system
board.
Replacing FRUs
Do not open your computer or attempt any repairs before reading the Important
Product Information Guide.
Replacing the heat sink.
Replacing the Wi-Fi card.
Replacing the computer stand.
Removing the computer cover.
Replacing the system board shield.
Replacing the VESA mount bracket.
Replacing the memory module.
Replacing the card reader.
Replacing the M.2 storage drive.
Replacing the serial connector module.
Replacing the microprocessor.
60
Advertisement
Table of Contents
