Cleaning And Maintenance - Champion CHSM210 User Manual

Cleaning and Maintenance

• Make sure that the unit is disconnected from the rower outlet when performing cleaning.
• Drain the remaining water in the tank and clean the tank after every use.
• Use detergent to clean the accessories (Jet Nozzle and Round Brush) when they are dirty.
EN
Then wash with cleaning water and air dry.
How to decalcify the Water Tank interior
To clean calcium deposits that build up inside the Water Tank, add one or two tablespoons of whi-
te vinegar to a full Water Tank close the Water Tank Cap and then shake the contents. DO NOT
TURN THE STEAMER ON.
Cleaning procedure to remove lime scale
• If your steam mop begins to produce steam more slowly than usual or stops producing steam,
you may need to remove lime scale. Lime scale can develop over time on the metal parts and
greatly affect the mop performance.
• It is necessary to remove lime scale on regular basis every 25-50 times you use a full tank
of water or at least once a month, especially in areas with hard water. The frequency of lime
scale removal depends upon the hardness of you tap water and how often you use the steam
mop.
1. Prepare a solution of 1/3 white vinegar and 2/3 tap water and add to the water tank.
2. Secure and position the unit to ensure steam released is aimed away from the floor or surroun-
ding objects and surface.
3. Plug the unit in, turn the unit ON by pressing the power switch, and allow the unit to produce
steam unit the vinegar/water solution in used up.
4. Repeat the above procedure as many times as necessary unit a normal steam flow rate is
achieved.
5. Fill the water tank with fresh water and rinse out.
6. Fill the water tank with fresh water, attach to the unit and releasee steam through the system
unit the water tank is empty.
! WARNING Don't leave the steamer unattended during the lime scale removal process and/or
while in use.
NOTICE:
Preform a test cleaning on a suitable isolated area after each lime scale removal to
ensure that there is no debris left in the system.
Cleaning steamer accessories
Due to the high mineral content of water in some areas, you may notice that less steam comes out
form the Hand-Held steamer accessories This may be caused by calcium buildup inside the tip of
the nozzle.
1. We recommend using a spray lubricant. Spray a small burst or two of the lubricant inside the
tip of the Jet Nozzle.
2. After spraying lubricant inside the component, fill the steamer with water according to the direc-
tions and run a continuous jet of steam through the affected accessory for several minutes to
remove the deposit once the steam pathway is clear.
3. Aim the steamer at a neutral surface or cleaning cloth to make sure no debris is emitted.
7