Table of Contents
Advertisement
3.10
Limiter Adjustment Procedure
( . 1 )
Set the C PU to permit ARY-03 to execute.
(2)
Connect the drive to the equipment body
(1541) .
(3) v Switch ON the power to the equipment and insert
a medium
(dummy)
into the drive and close the door.
Press 1 A ! and
IRET! k e y s .
Loosen the limiter screw a 1/4 turn, counter clock.
wise, position the limiter as
■ V
instructed belew,
then retichten the screw.
(T) Move the limiter in (g)c> direction
until is stops.
(?) Next, move it
0.25 :to .0,.4mm''in
(S) £ >
direction.
Held the limiter using a screwdriver
as a lever sc that the limiter does
not rotate cocrehuer w' iuh m e
screw when in
is tightened.
(Be careful not to damage the steel
belt with the screwdriver.)
As a criterion for
screw tightening,
the screw should not move when
a torque of 5 kc-cn is applied to it.
2 1
Advertisement
Chapters
Table of Contents
