Related Manuals for 3M 33579
Summary of Contents for 3M 33579
- Page 1 OPERATOR’S MANUAL & SAFETY INSTRUCTIONS 3M™ Cut-Off Wheel Tool PN 33579 76 mm (3 in.) 20,000 RPM PN 33581 101 mm (4 in.) 20,000 RPM 2017-02-21, Version 2 Translation of Original Instructions...
-
Page 2: Table Of Contents
3M LIMITED ONE YEAR WARRANTY . . . . . . . . . . . . . . . . . . -
Page 3: Important Safety Information
IMPORTANT SAFETY INFORMATION Please read, understand, and follow all safety information contained in these instructions prior to the use of this device . RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE . Read the Safety Data Sheets (SDS) WARNING before using any materials. Exposure to DUST generated from workpiece and/or abrasive materials can result in lung damage and/or other physical injury. -
Page 4: Explanation Of Signal Word Consequences
EXPLANATION OF SIGNAL WORD CONSEQUENCES Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury and/or WARNING: property damage . Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury and/ CAUTION: or property damage . -
Page 5: Warning
(mounting hardware, abrasive product, etc .) . Correct or replace the suspect component . If abnormal noise or vibration still exists, return the tool to 3M for repair or replacement . Refer to warranty instructions . • Only personnel who are properly trained should be allowed to service this tool . -
Page 6: Caution
. It should only be used for such applications and within its marked capacity and rating . PN 33579 uses a 76 mm (3 in) diameter abrasive, while PN 33581 uses a 101 mm (4 in) diameter abrasive . -
Page 7: Exploded Tool (Parts) View
EXPLODED TOOL (PARTS) VIEW Wheel PARTS LIST ITEM DESCRIPTION ITEM DESCRIPTION ITEM DESCRIPTION ITEM DESCRIPTION 3 in. Wheel Guard Ball Bearing (626ZZ) 3 in . (76mm) Wheel Guard Ball Bearing (626ZZ) 4 in. Wheel Guard Spring Pin ( 2.5x26) Ø Hex. Screw Valve Screw 4 in . -
Page 8: Maintenance/Lubricating And Operating Instructions
. If such equipment is not used, the tool should be manually lubricated . To manually lubricate the tool, disconnect the airline and put two to three drops of 3M™ Air Lubricant PN 20451 (or equivalent 10 centistoke oil) into the air inlet of the tool . - Page 9 • Always disconnect the air supply to the tool before fitting, adjusting or removing the abrasive cut-off wheel . • Use only 3M approved parts . • Prior to installing any abrasive cut-off wheel, always check that its marked maximum operating speed is equal to or higher than the rated speed of this tool .
-
Page 10: Declaration Of Conformity
DECLARATION OF CONFORMITY Discover other air cutting tools on our website.