Restore Factory Settings; Troubleshooting - Horizon Fitness MH50 Quick Start Manual

Note: The default user name is admin; the default password is admin.
You can also find the label for default log in username and password printed on the device label
by removing the back cover and battery.
How to change the SSID &Password
1. While your computer or other device terminal is connected to the hotspot, log in to
http://192.168.1.1
and password.
2. In the WebUI,Select Settings> Wireless> WLAN Settings, then you will see "Wi-Fi Name(SSID) "
and "Password". Delete the old name and password and enter your new name and password.
3. Select "Apply" button, wait for the screen to display "Success", and then log out.
4. Wait for the computer or other device terminal screen to display the Wi-Fi icon. This means
the wireless network connection was successful.

Restore Factory Settings

If you are uncertain of which Wi-Fi settings you have configured or changed, you can restore the
factory defaults that come with the device to reconfigure the device Wi-Fi setting.
1. Log into Device Management in the WebUI to restore your hotspot to its factory default
settings.
2. On the hotspot, press and hold "Reset" button for 5 seconds, and the device will restart
with restored factory default settings.
Note: Resetting will delete all of the device's user-defined Wi-Fi settings and restore all settings
to factory default values.
Trouble Shooting:
If you are having trouble with device, here are a few troubleshooting tips:
1. If the device is not responsive, restart it by press the "Power" button for about 8 seconds
2. If restarting the device does not solve the issue, try restoringthe deviceto its default factory
settings.
Q&A
Q: What do I do if I see the SSID but failed to connect?
A: 1 Check if the password you entered is the correct one.
2 Check if WPS security is enabled on your PC. If so, check the device to see if it isexpecting a
WPS action from your PC.
Q: What to do if there is No service?
A: The possible reasons are an unstable network signal or a hardware problem.
You can try the following solutions:
1.If you are inside a building or near a structure that may be blocking the signal, change the
position or location of the device. For example, try moving the device close to a window.
2.Check the hardware for any loose parts or damage.
or http://device.WebUIin an internet browser using the default username