Advertisement
4.
OPERATION
4.1.
Regulator - The output pressure is controlled by the knob. Before pressurising air system for the first time lift and rotate knob anticlockwise
to remove any loading on the regulator spring. Pressurise the system and then rotate knob clockwise to set required output pressure,
as shown on gauge. When the required pressure is achieved lock knob by pushing down.
Note: For correct pressure setting always adjust upwards from a lower pressure. Therefore to
reset from 90 to 70psi, for example, reduce pressure from 90 to 60psi and then increase
from 60 to 70psi.
4.2.
Filter - The bowl will automatically drain each time the system pressure drops to zero.
However, if the fluid level reaches the maximum mark but the system is to remain
pressurised the bowl can be manually drained by pushing the drain stub upward. Note
that the stub is designed to take a flexible tube so that the waste fluid can be piped away.
4.3.
Lubricator - Remove filler plug (fig.2.A) and fill bowl with air tool oil. This can be done
with air line pressurised.
With air flowing through the lubricator the oil delivery rate can be adjusted by screw ‘B’
whilst watching the drip rate through the sight dome ‘C’. The oil delivery rate will be
automatically increased or decreased in line with the air flow.
5.
ADDITIONAL FITTINGS
The following fittings are available from your local Sealey supplier:
SA1/1414 . . . . . . . . . .1/4”BSP-1/4”BSP male-male nipple
SA1/1212 . . . . . . . . . .1/2”BSP-1/2”BSP male-male nipple
SA1/3814F . . . . . . .3/8”BSP-1/4”BSP male-female reducer
SA1/1214F . . . . . . .1/2”BSP-1/4”BSP male-female reducer
SA1/1238F . . . . . . .1/2”BSP-3/8”BSP male-female reducer
6.
DECLARATION OF CONFORMITY
Declaration of Conformity
Filter/Regulator/Lubricator,
Filter/Regulator, Filter & Lubricator.
Models: SA2001, SA2001/FR, SA2001/F
& SA2001/L
97/23/EC Pressure Equipment Directive
98/37/EC Machinery Directive
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
We, the sole importer into the UK, declare that the products listed here are in conformity with the following standards and directives.
The construction files for these products are held by the Manufacturer and may be inspected, by a national
authority, upon request to Jack Sealey Ltd.
Signed by Mark Sweetman
For Jack Sealey Ltd. Sole importer into the UK of Sealey Power Products.
Sole UK Distributor,
Sealey Group,
Bury St. Edmunds,
Suffolk.
Date 19th October 2001
01284 757500
E-mail: sales@sealey.co.uk
fig. 2
01284 703534
SA2001/FR/F/L - 1 - 161001
Advertisement
