SNOWJOE iON iON18SBRM Operator's Manual

SNOWJOE iON iON18SBRM Operator's Manual

40 v cordless snow blower
Hide thumbs Also See for iON iON18SBRM:

Advertisement

Quick Links

A Division of Snow Joe
, LLC
®
IMPORTANT!
Safety Instructions
All Operators Must Read These
Instructions Before Use
Read all instructions when using cordless snow blowers.
Basic safety precautions should always be followed to reduce
the risk of fire, electric shock, and personal injury.
General Safety Rules
Notice the personal safety alert symbol
manual to draw your attention to a WARNING given along
with the particular operating instruction. This means that
the operation requires special ATTENTION, CAUTION, and
AWARENESS.
• Keep work area clean and well lit – Cluttered, dark areas
invite accidents.
• Keep bystanders away – All bystanders and pets should
be kept a safe distance away from the work area.
• Dress properly – Do not wear loose clothing or jewelry.
They can get caught in moving parts. Protective rubber
gloves and non-slip footwear are recommended when
working outdoors.
• Use the right product – Do not use this machine for any
job except that for which it is intended.
m
CAUTION! – Exercise caution to avoid slipping or falling.
Wear protective footwear that will protect your feet and
improve your footing on slippery surfaces.
• Use safety glasses – Also use safety footwear, snug-fitting
clothing, protective gloves, hearing and head protection.
• Do not force the snow blower – Use the snow blower
at the rate for which it was designed to ensure optimal
performance and safe operation.
• Stay alert – Watch what you are doing. Use common
sense. Do not operate the snow blower when you are tired
or under the influence of alcohol or drugs.
• Do not overreach – Keep proper footing and balance at
all times.
• Store indoors – When not in use, the snow blower should
be kept dry and stored out of the reach of children in a high
or locked place.
• Maintain snow blower with care – Follow instructions for
lubricating and changing accessories.
© 2014 by Snow Joe
, LLC
®
All rights reserved. Original instructions.
40 V Cordless Snow Blower
40 V Cordless Snow Blower
Model No. iON18SBRM
m
used in this
m
WARNING!
Turn off the power switch and disconnect
the battery before making any adjustments, inspecting,
servicing, changing accessories, cleaning the snow blower,
or when any other dangerous conditions present. Any
such operation should be performed after revolving parts
inside the snow blower stop completely. Such preventive
safety measures reduce the risk of starting the power tool
accidentally.
m
WARNING!
When replacing any parts, you must strictly
observe the instructions and procedures described in this user
manual. Special care should be paid to any rubber parts, since
these parts may increase the engine load and decrease its
mechanical power if damaged.
m
WARNING!
If you notice that the snow blower is not
running properly or hear abnormal sounds from the engine
when it is in use, immediately stop the machine, disconnect
the battery, and contact your service center.
• Surfaces – This snow blower is intended for use on
paved surfaces. Do not use on gravel, stone or other
unpaved surfaces unless the snow blower is adjusted for
such surfaces according to the instructions given in the
operator's manual.
• Moving parts present risks – Keep your face, hair,
clothing, hands, and feet away from moving parts. All
guards and safety attachments must be installed properly
before using the unit. Shut off and disconnect the battery
before touching any parts other than the handles and
switch.
• Avoid unintentional starting – Make sure the safety switch
and the switch bar lever are in the off position before
inserting the battery in the unit. Do not carry the snow
blower with the safety switch and the switch bar lever
engaged.
• Do not overreach – Maintain proper footing and balance
at all times. Place heels firmly on the ground and tightly
grasp the handle bar. Watch for uneven surfaces and do not
overreach. In case you fall or collide with the snow blower,
inspect the unit for any damages or cracks. When stepping
backwards, be careful to avoid obstacles beneath your feet
or behind you to avoid falling.
m
WARNING!
If the snow blower strikes any object,
follow these steps:
i) Stop the snow blower. Remove the battery.
ii) Inspect for damage.
iii) Repair any damage before restarting and operating
the snow blower.
SAVE THESE INSTRUCTIONS
1
Form No. SJ-iON18SBRM-880E
OPERATOR'S MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the iON iON18SBRM and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for SNOWJOE iON iON18SBRM

  • Page 1 40 V Cordless Snow Blower 40 V Cordless Snow Blower Model No. iON18SBRM Form No. SJ-iON18SBRM-880E OPERATOR’S MANUAL A Division of Snow Joe , LLC ® IMPORTANT! WARNING! Turn off the power switch and disconnect the battery before making any adjustments, inspecting, Safety Instructions servicing, changing accessories, cleaning the snow blower, or when any other dangerous conditions present.
  • Page 2: Additional Safety Instructions

    Battery & Charger Safety always unplug the charger before performing any cleaning or maintenance task. Do not allow water to flow into the AC/DC Instructions plug. Use a Ground Fault Circuit Interrupter (GFCI) to reduce shock hazards. WARNING! • Do not burn or incinerate battery packs – Battery packs Use only approved replacement batteries;...
  • Page 3: Electrical Safety

    Special care should be paid to any rubber parts, since perform a test run the first time you use the snow blower or after replacing parts to ensure that the unit is functioning these parts may increase the engine load and decrease its properly.
  • Page 4: Safety Symbols

    Safety Symbols The following table depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbols Descriptions Symbols Descriptions Wear hearing protection. Wear eye protection. Safety Alert.
  • Page 5: Technical Data

    Know Your Cordless Snow Blower Read the owner’s manual and safety rules carefully before operating the snow blower. Compare the illustration below to the snow blower in order to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. 1.
  • Page 6: Carton Contents

    Unpacking 2. Secure the connection of the middle frame to the upper frame by fastening the handle locks on each side (Fig. 2). Carton Contents: Fig. 2 • Cordless snow blower • 40 V EcoSharp battery ™ • EcoSharp battery charger ™...
  • Page 7: Discharge Chute Assembly

    Discharge Chute Assembly Powering On and Off 1. Lift the chute deflector until it locks securely into place on 1. Open the battery compartment cover and slide the battery the discharge chute. down to lock it into position (Fig. 7). 2.
  • Page 8: Operating Tips

    3. To power on, first press the safety switch button found stop the snow blower, remove the battery, remove the alongside the switch housing (Fig. 10). obstruction, and inspect the unit for damage. Repair or replace any damaged part before restarting and operating the unit.
  • Page 9: Battery Pack Operation

    11. The LED light can be adjusted by moving it up and down Fig. 15 as depicted (Fig. 13). Fig. 13 Deflector knobs WARNING! Make sure that the chute deflector locks completely onto the discharge chute. An opening between Changing Throw Direction and Throw the discharge chute and the chute deflector may allow foreign objects to be picked up by the snow blower and thrown in the Height...
  • Page 10: Cold Weather Operation

    Cold Weather Operation 3. The red light will turn on to indicate that the charger is working and the battery is being charged. The Snow Joe EcoSharp iBAT40 lithium-ion battery pack ® ™ NOTE: A flashing red light indicates that the battery pack can be safely used at temperatures ranging from -4ºF (-20ºC) is either too hot or too cold.
  • Page 11: Charging A Hot Or Cold Battery Pack

    Charging a Hot or Cold Battery Pack 3. Use only mild soap on a damp cloth to clean the battery pack and charger, keeping away from all electrical The red flashing indicator light on the charger indicates that contacts. Certain cleaning agents and solvents are the battery pack temperature is outside the charging range.
  • Page 12: Environmentally Safe Battery Disposal

    Replacing the Scraper Bar damage the charger and the battery pack. Do not use oil or solvents to clean or lubricate your battery pack as the 1. The scraper bar is located at the base of the snow blower plastic casing can become brittle and crack, causing a beneath the rotor housing (Fig.
  • Page 13 NOTES...
  • Page 14: In The United States And Canada

    If in the event your efforts ® are unsatisfactory, please write to the Snow Joe Center at the above address. ® If you have any questions about your product warranty, please call 1-866-SNOW-JOE or visit us online at www.snowjoe.com.

Table of Contents