Willis WST12MC16S Service Manual page 21

Function and Control
3
Press this button to decrease set temperature.Holding it down above 2 seconds rapidly
AUTO mode, set temperature is not adjustable.
+
:
4
Press this button to increase set temperature.Holding it down above 2 seconds rapidly increases set temperature. In
AUTO mode, set temperature is not adjustable.
5
FAN :
This button is used for setting fan speed in the sequence that goes from AUTO,
6
:
●
Press button to start or stop up & down swing function.The remote controller defaults to simple swing condition.
●
Press + button and
blinking 2 seconds.
In static swing condition, press
●
●
If the unit is turned off during swing operation,the louver will stop at present position.
7
HEALTH SAVE:
Press HEALTH part of this button to turn on or off HEALTH function.
and the unit goes into SAVE operation mode. Press SAVE part of the button again to cancel SAVE function .During
SAVE operation, the tmperature and fan speed is not adjustable.
:
8
●
Press button to start or stop left & right swing function.The remote controller defaults to simple swing condition.
●
Press + button and
blinking 2 seconds..
In static swing condition, press
●
●
If the unit is turned off during swing operation,the louver will stop at present position.
9
X-FAN:
Pressing X-FAN button in COOL or DRY mode,the icon "X-FAN" is displayed and the indoor fan will continue operation
for 10 minutes in order to dry the indoor unit even though you have turned off the unit.
After energization, X-FAN OFF is defaulted. X-FAN is not available in AUTO,FAN or HEAT mode.
10 TEMP:
Pressing TEMP button,
temperatur) is displayed circularly .The unit defaults not to display the icon. During operation of TEMP button, the set
temperature is always displayed.
Note: Outdoor ambient temperature is only displayed for some models.
.
Auto
Medium speed
Low speed
button at the same time at unit OFF to switch between simple swing and static swing,
button, the swing angle of up & down louver changes as below:
button at the same time at unit OFF to switch between simple swing and static swing,
button, the swing angle of left & right louver changes as below:
(set temperature),
,
High speed
Pressing SAVE part of this button,
(indoor ambient temperature) and
decreases set temperature. In
,
,
to then back to Auto.
is displayed
(outdoor ambient
27