Page 1
22.5 In. Kettle Charcoal Grill Model # OCR-2250A OUTDOOR USE ONLY! NEVER USE INDOORS! CARBON MONOXIDE HAZARD Burning charcoal inside may be fatal. It gives off carbon monoxide, which has no odor. NEVER burn charcoal in enclosed spaces. Read and follow all of the manufacturer instructions before beginning assembly or operation. Failure to do so could result in fire, burns, or other serious personal injury.
Model #OCR-2250A IMPORTANT SAFETY INFORMATION DANGER Failure to follow the dangers, warnings, and cautions in this manual may result in serious bodily injury, or death, as well as property damage due to a fire or explosion. WARNING CALIFORNIA PROPOSITION 65 ...
Page 3
Model #OCR-2250A Grill Preparation Safety WARNING DO NOT use this grill without the ash catcher (if available), ash pan, or ash tray in place. DO NOT use this grill unless all parts are in working condition and properly installed.
Page 4
Model # OCR-2250A Grill is hot when in use. To avoid burns: DO NOT attempt to move the grill while lit or still hot. ALWAYS wear protective gloves or oven mitts. DO NOT TOUCH any hot grill surfaces.
Model #OCR-2250A Table of Contents Important Safeguards………………………………………………Page 2 Preparation……………………………………………………………………..5 Exploded View………………………………………………………………...6 Parts List………………………………………………………………………..7 Hardware & Tools…………………………………………………………...8 Assembly Instructions……………………………………………………..9 Care & Maintenance………………………………………………………14 Operating Instructions…..……………………………………………….14 Cleaning & Care……………………………………………………………..17 Limited Warranty…………………………………………………………..18 Preparation DO NOT RETURN PRODUCT TO STORE For assistance, please email customerservice@sanxinint.com...
Model #OCR-2250A Assembly Instructions Step 1 Connect the Handle (3) to the Lid (4) with Washers (E) and M6 Wing Nut (G). Next, attach the Lid Air Vent (1) to the top of the Lid (4) using M5x10 Bolt (C), Washer (F) and M5 Wing Nut (H).
Page 10
Model #OCR-2250A Step 3 Attach the Left Bowl Hinge (7) and Right Bowl Hinge (8) to the Bowl (10) with M6x12 Screws (A) and Washers (E). Note: the hinges will point straight away from the bowl when assembled correctly. Secure the Lock (13) to the Bowl (10) by threading M5*8 Screws (D) into the back of the lock.
Page 11
Model #OCR-2250A Step 5 Place the Wheel Legs (16) on to the longer axle portion of the Bottom Shelf (19). Place the Stationary Legs (17) on to the front of the Bottom Shelf (19). Slide the top of each leg into the Leg Connectors.
Page 12
Model #OCR-2250A Step 7 Place the Lid on top of the Bowl making sure the lid hinges slide inside of the bowl hinges. Connect the Lid to the Bowl by placing Hinge Pin (K) through the hinge holes and secure with Cotter Pin (L).
Page 13
Model #OCR-2250A Step 9 Place the Charcoal Grid (12) in the bottom of the Bowl. Place the Cooking Grid (11) on the top edge of the Bowl. Step 10 Slide the Ash Catcher (15) into the bottom of the Bowl from the right side of the grill.
Model #OCR-2250A Care & Maintenance Wash cooking grids and charcoal grates with hot, soapy water. Rinse well and dry completely with a towel to prevent rusting. After washing and drying, lightly coat grids with vegetable oil or vegetable oil spray.
Page 15
Model #OCR-2250A Lighting Instructions (continued) Never add charcoal starter fluid to hot or warm coals as flashbacks may occur causing injury. You are ready to begin cooking when the pile of briquettes ashes over and produces a red glow (approximately 10-15 minutes).
Page 16
Model #OCR-2250A Controlling Flare-ups Flare-ups are a part of cooking meats on a charcoal grill and adds to the unique flavor of grilling. Excessive flare-ups can over cook your food and cause a dangerous situation for you and your charcoal grill.
Model #OCR-2250A Cleaning & Care CAUTION! All cleaning and maintenance should be done when charcoal grill is cool and with the fuel supply removed. Notices Abrasive cleaners will damage this product. Never use oven cleaner to clean any part of this charcoal grill.
If Sanxin Co., Ltd. confirms, after examination, a defect covered by this Limited Warranty in any returned part, and if Sanxin Co., Ltd. approves the claim, Sanxin Co., Ltd. will replace such defective part without charge. If you return defective parts, transportation charges must be prepaid by you.