LG DLE3 0 Series Owner's Manual page 33

Check the Duct Condition
If the Flow Sense™ Display is turned on, check the
exhaust system for restrictions and damage. Repair
or replace the exhaust system as needed.
NOTE
• When the dryer is first installed, this test should be
performed to alert you to any existing problems with
the exhaust duct in your home. However, since the
test performed during normal operation provides
more accurate information on the condition of the
exhaust duct than the installation test, the number
of bars displayed during the two tests may not be
the same.
• Do not interrupt the test cycle, as this could result in
inaccurate results.
• Even if the Flow Sense display does not light up
during the test cycle, some restrictions may still be
present in the exhaust system. Refer to the Venting
the Dryer section of this manual for complete
exhaust system and venting requirements.
Error Codes
Check the error code before you call for service.
Error Possible
Code Causes
tE1 or Temperature
tE2 sensor failure.
Humidity sensor
HS
failure.
Electric dryer
power cord is
not connected
correctly, or
house power
supply is
incorrect.
PS,
PF, or
nP
House fuse is
blown, circuit
breaker has
tripped, or
power outage
has occurred.
Gas supply or
gAS
service turned
off. (Gas Model
only.)
Solutions
Turn off the dryer and call
for service.
Turn off the dryer and call
for service.
Check the power supply
or the connection of
the power cord to the
terminal block. Refer to
the Connecting Electric
Dryers section of this
manual for complete
instructions.
Reset circuit breaker
or replace fuse. Do
not increase the fuse
capacity.
If the problem is a
circuit overload, have it
corrected by a qualified
electrician.
Confirm that house gas
shutoff and the dryer
gas shutoff are both fully
open.
Restricted or Blocked Airflow
Avoid long runs or runs with multiple elbows or
bends.
Excess or crushed
transition duct
Check for blockages and lint buildup.
Lint buildup or blockage Lint buildup or blockage
Make sure the ductwork is not crushed or restricted.
INSTALLATION 33
Too many elbows or
exhaust too long
Crushed or damaged Crushed or damaged
exhaust exhaust