LG DLE3 0 Series Owner's Manual page 29

Three-Wire Power Cord
• A 3-wire connection is NOT permitted
on new construction after January 1,
1996.
• A UL-listed strain relief is required.
• Use a 30-amp, 240-volt, 3-wire,
UL-listed power cord with #10 AWG-
minimum copper conductor and closed
loop or forked terminals with upturned
ends.
1
Remove the terminal block access cover on the
upper back of the dryer.
2
Install a UL-listed strain relief into the power
cord through-hole.
3
Thread a 30-amp, 240-volt, 3-wire, UL-listed
power cord with #10 AWG-minimum copper
conductor through the strain relief.
UL-Listed 3-Wire Power UL-Listed 3-Wire Power
Cord Cord
4
Attach the two hot leads (black and red) of the
power cord to the outer terminal block screws.
5
Attach the neutral (white) wire to the center
terminal block screw.
6
Connect the external ground (if required by local
codes) to the green ground screw.
7
Tighten all screws securely.
8
Ground Screw Ground Screw
White Wire from Dryer White Wire from Dryer
harness harness
Terminal Block Terminal Block
UL-Listed Strain UL-Listed Strain
Relief Relief
INSTALLATION
Reinstall the terminal block access cover.
Hot (Black) Hot (Black) Neutral (White) Neutral (White)
External Ground Wire (If External Ground Wire (If
required by local codes) required by local codes)
29
Hot (Red) Hot (Red)