For The First Use; Operation; Cleaning And Maintenance - Electrolux E2TS1-100W Instruction Book

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

FOR THE FIRST USE

EN
As there is manufacturing residue or oil remained in the toaster or heat element, it usually emits the odor
for the first use. It is normal and will not occur after several times use. Before toasting the first slice of bread
it is strongly suggested to operate the appliance following below instructions, except without bread.
ID
TH

OPERATION:

1. Put bread slice into the bread slot, it can be inserted two slices at most every time. Only the regular
VN
slice can be placed into the bread slot. The irregular bread can only be toasted on the toasting rack
and only one piece every time. When toasting on the toasting rack, press down the rack control handle
AR
to make the toasting rack uplift, then put the bread on the toasting rack. Lift the rack control handle to
reset the rack when do not use.
Note: Make sure the crumb tray is completely positioned in place before using.
2. Plug the power cord into the outlet.
3. Set color control knob to your desired color. There is 7-position level, the lowest is white and the highest
is puce. The bread slice can be toasted to golden color at the position of "4".
Note: 1) Toasting color for one side is darker than that for double bread at the same level.
2) If toasted continuously, toasting color for the latter bread is darker than the color of previous cycle
at the same level.
4. Press carriage handle down vertically until it is positioned in place, the indicator of STOP will be
illuminated, and toasting begins. Once the bread has been toasted to the preset color, the carriage
handle will be automatically sprung up, and you can remove the bread readily.
Note: The carriage handle can only be latched when the appliance connects to the power supply.
5. During the toasted process, you may observe the toasting color. If it is satisfactory, you may interrupt
the toasting process by pressing the STOP button at any time.
6. If the bread has been taken out from refrigerator. Set color control knob to your desired color. Press
carriage handle down vertically until it is positioned in place, then press DEFROST button and the
indicator of DEFROST will be illuminated. In this mode it will be toasted to your desired color.
7. If you want to reheat the cold toasted bread. Press carriage handle down vertically until it is positioned
in place, then press REHEAT button and the indicator of REHEAT will be illuminated. In this mode
toasting time is fixed, so long as time is running over, the carriage handle will automatically spring up
and end up the reheating process.
CAUTION:
1. Remove all protective wrapping prior to toasting.
2. If toaster starts to smoke, press STOP button to stop toasting immediately.
3. Avoid toasting the food with extremely runny ingredients such as butter.
4. Never attempt to remove bread jammed in the slots without unplugging the toaster from the electrical
outlet first. Be sure not to damage the internal mechanism or heating elements when removing bread.
5. The bread slot is only applicable for toasting regular bread slice. Like the irregular bread or round
bread, you can toast it on the toasting rack.
6. There is a dust-proof cover, when not use, you can put it on the top of the toaster to prevent dust.

CLEANING AND MAINTENANCE:

1. Disconnect the power supply before cleaning.
2. Wipe the outside with soft dry cloth after toaster cools down, never use metal polish.
3. Pull out the crumb tray on the bottom of toaster by crumb tray handle and empty it. If toaster is used
frequently, accumulated bread crumbs should removed at least once a week. Make sure the crumb tray
is completely closed before using the toaster again.
4. When not use or storage, the power cord may be wound under the bottom of toaster.
4
www.electrolux.com

Advertisement

Table of Contents
loading

Table of Contents