Advertisement
1. The range hood should be
mounted at a distance of
600mm (24") from an electric
or induction cooktop, and
762mm (30") above a gas cooktop
for safety and optimum performance.
If the instructions for installation of
the gas cooktop specify a greater
distance, this has to be taken into
account (see pic 1). The exhaust air
must not be discharged into a flue which is
used for exhausting fumes from other appliances
burning gas or other fuels.
2.
Ensure that the wall the hood is to be installed on is
sufficiently sturdy to carry the weight of the hood. It
should be mounted level for best performance.
3. Install the cabinet on the wall.(see pic 2)
Drill 2x8mm holes through the metal tabs at the rear
of the cabinet into the wall.
4.
Attach the duct to the one way valve, and connect it to
the kitchen outlet vent (see pic 3)
5. Fit the hood into the cabinet and secure with 4 screws
in the 4 bottom corners.(see pic 4,5)
6. Do not connect to a common vent with any other
appliances such as a gas heater, water heater,
washer/dryer,etc.
7. The duct should not be bent more then 120° from
the one way valve outlet in the kitchen vent.
1
1. Clean the surface of the hood every week with
mild soap or detergent. Avoid solvents, acid, alkali,
scouring pads or power that could irreparably
damage the stainless steel surface.
2. The grease filters may be washed using mild soap,
detergent or degreasing agents.
3. The filters can be washed in a dishwasher.
4. The charcoal filters cannot be cleaned and must
be generally replaced after 6 months of use.
13
Advertisement
