Table of Contents
Advertisement
15.6 Resetting the appliance
network settings
Press and hold Remote Start
1.
at least 3 seconds.
Set the programme to position 5.
2.
a The display shows rES.
Press Start/Reload
3.
a The display shows YES.
Press Start/Reload
4.
a The network settings are reset.
a If End is shown on the display, the
network settings are reset.
15.7 Remote start
Enable the appliance for remote start
via the Home Connect app.
Activating remote start
Notes
¡ Remote start is deactivated for
safety reasons in the following
circumstances:
– Open the appliance door.
– Press Start/Reload
– Press Remote Start .
– Switch off the appliance.
– Following a power cut.
¡ For safety reasons, remote start
cannot be activated if the appli-
ance door is open.
Requirements
¡ The appliance is connected to your
Wi-Fi home network.
¡ The appliance is connected to the
Home Connect app.
¡ A programme is selected.
Press Remote Start .
▶
If you press and hold the button
for at least 3 seconds, the
Home Connect menu opens.
If you briefly press the button, the
appliance is enabled for remote
start via the Home Connect app.
for
.
.
.
If you open the appliance door, the
function is automatically deactiv-
ated.
a Remote Start
Note: To deactivate the function,
press Remote Start .
15.8 Remote diagnostics
Customer Service can use Remote
Diagnostics to access your appliance
if you contact them, have your appli-
ance connected to the Home Con-
nect server and if Remote Dia-
gnostics is available in the country in
which you are using the appliance.
Tip: For further information and de-
tails about the availability of Remote
Diagnostics in your country, please
visit the service/support section of
your local website: www.home-con-
nect.com
15.9 Data protection
Please see the information on data
protection.
The first time your appliance is
registered on a home network
connected to the Internet, your
appliance will transmit the following
types of data to the Home Connect
server (initial registration):
¡ Unique appliance identification
(consisting of appliance codes as
well as the MAC address of the
Wi-Fi communication module in-
stalled).
¡ Security certificate of the Wi-Fi
communication module (to ensure
a secure data connection).
¡ The current software and hardware
version of your appliance.
¡ Status of any previous reset to
factory settings.
Home Connect en
lights up.
35
Advertisement
Table of Contents
