Table of Contents
Advertisement
When tightening the screw, use a torque driver (RFKZ0456) by ordering the screwing order with specifed torque described in each step.
4.3.1 Installation of the Rear frame unit
1. Tighten 1 screw (F) for fxing the Rear frame unit in numerical order by using the torque driver with specifed torque.
Then, install the Focus enc holder to bosses.
After that, tighten 2 screws (E) for fxing the Focus enc holder and the Focus ring earth spring in numerical order by using the torque driver
with specifed torque.
(Torque Driver : RFKZ0456)
(Torque : 8 ± 1 N cm)
*How to install the Focus enc holder.
(1) Put boss
into a positionning hole (long) of the Focus enc holder.
(2) Deform the Focus enc holder in the direction of the arrow.
(3) Put boss
into the other positionning hole (circle) of the Focus enc
holder.
Note:
file:///C|/U...al/Temp/Rar$EXa0.393/viewing/SGML_VIEW_DATA/ALL/H-HS043PP/SVC/DSC1504015CE/doc/DSC1504015CE_04.xml[11/12/2018 3:39:43 PM]
Advertisement
Table of Contents
