1. Manuals
  2. Brands
  3. Gentec-EO Manuals
  4. Digital Camera
  5. Beamage-3.0
  6. Installation procedure

Gentec-EO Beamage-3.0 Installation Procedure

Usb 3.0 beam profiling camera
Hide thumbs Also See for Beamage-3.0:
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Beamage-3.0 and is the answer not in the manual?

Questions and answers

Related Manuals for Gentec-EO Beamage-3.0

Summary of Contents for Gentec-EO Beamage-3.0

  • Page 2 These steps must be followed in the specified order. 1. Install the PC-Beamage-3.0 software. 2. Install the Beamage-3.0 USB driver by following the Beamage-3.0 Driver Installation Quick Guide (refer to p.3). The driver must be reinstalled if a new version of software was updated;...
  • Page 3 Revision 2.0 DRIVER INSTALLATION GUIDE 1) Do not connect the Beamage-3.0’s USB cable to your computer before installing the appropriate software and drivers. The camera will not be recognized if so. 2) The latest available version of PC-Beamage-3.0 must be installed before setting the drivers. It can be downloaded from the Download tab in the bottom of the following web page: https://gentec-eo.com/products/beam-diagnostics/Beamage-3.0.
  • Page 4 Beamage-3.0 Installation Procedures Revision 2.0 Figure 2: Choose your system 6) After choosing the operating system, you will be asked to unplug the camera. If you followed the former steps, the camera should already be unplugged. Click on OK. Figure 3: Unplug the camera 7) You will be asked if you want to allow the program to make changes to your computer.
  • Page 5 Beamage-3.0 Installation Procedures Revision 2.0 Figure 4: Device Driver Installation Wizard 9) Once the installation is completed, click on Finish. Figure 5: Installation Completed...
  • Page 6 Figure 6: Driver installed successfully (1) Figure 7: Connect the camera 11) Another window will inform you that you can now use PC-Beamage-3.0. Click on OK. Figure 8: You can now use PC-Beamage-3.0 12) To allow the device to be recognized by your computer, unplug and plug back the USB cable.
  • Page 7 Beamage-3.0 Installation Procedures Revision 2.0 13) Start the PC-Beamage-3.0 application. A camera selector will appear, with a series of zero as the single option. Meanwhile, the last driver will be installed. Wait for the following message to appear at the bottom right of your screen. Click on OK in and close the application.
  • Page 8 5) Click on “Update”. Figure 12 6) The Beamage-3.0 Updater might ask you to reset the Beamage-3.0. If so, please disconnect and reconnect the Beamage-3.0 and click on “Update” again. 7) Once this is done, a message box will appear. Click on OK.

Table of Contents