J39L_EA.book Page 22 Saturday, June 8, 2002 5:35 PM
Knowing Your Mazda
Doors and Locks
NOTE
Roof racks increase wind turbulence
which can result in noise. This does
not indicate an abnormality. The roof
rack can be removed when it is not
needed.
M Roof Rack Adjustment
1. Loosen the screw at both ends of the
rear cross bar, then remove the rear
cross bar covers.
Screw
Rear cross bar cover
2. Loosen the bolt at both ends of the rear
cross bar, then slide the rear cross bar
to the desired position.
Bolt
3-22
Form No. 8Q94-EA-02G
3. Tighten the bolt at both ends of the rear
cross bar alternately and evenly.
NOTE
• If only one bolt is tightened, the
• Tighten the bolts with tightening
Rear cross bar
4. Install the rear cross bar cover by
inserting the clips into the square hole
of the rear cross bar until they click,
then tighten the screw.
Rear cross bar
cover
Bolt
cross bar will lean to one side.
torque of 11—12 N•m {110—120
kgf•cm}.
Screw
Rear cross bar