Stealth Cam Reactor Instruction Manual page 17

DVR MODE: This setting allows you to
continuously record new images. Turning this
setting ON will continuously delete oldest recorded
files to make space for new files. When turned
OFF, the camera will stop recording new files when
SD card reaches capacity.
OPTIONS: On | Off
TEMPERATURE: This setting is used to change
temperature format on Info Bar.
OPTIONS: Fahrenheit | Celsius
LONGITUDE and LATITUDE: This setting allows you
to manually enter the longitude and latitude of your
camera.
OPERATING HOURS: This feature allows you to
designate a time for the camera to be active.
OPTIONS:
24/7: Camera is always on
SCHEDULED: Selecting this will allow you to
enter a time range for the camera to be active
and operational. Camera will not take photos
outside of defined time range.
START TIME (HH:MM): Start time for
camera to be active
END TIME (HH:MM): Time at which you
want the camera to no longer be active
INFORMATION BAR: This setting is used to
tell the camera whether the Info Bar should be
displayed at the bottom of images.
OPTIONS: On | Off
VIDEO LENGTH: This setting is used to determine
the length of time, in seconds, of a video recording.
Video records for 10 seconds.
VIDEO AUDIO: This setting will determine if the
video records with or without audio. Recording audio
with each video will take additional memory space.
OPTIONS: Off | On
ERASE CARD: This setting is used to format the SD
memory card installed. Formatting your SD card will
ERASE ALL DATA PRESENT.
NOTE: After card is formatted it is impossible to
restore data that was present on card.
TIME LAPSE (TL) DELAY: This setting will adjust
the length of time between each photo taken during
the time lapse.
OPTIONS: 00 min 05 sec - 59 min 59 sec
TL START: This setting is used to determine the start
time of the time lapse.
TL STOP: This setting is used to determine the end
time of the time lapse.
Page 17