Hyundai 2006 Azera Owner's Manual page 215

3
WHAT TO DO IN AN EMERGENCY
8
D060E01A-AAT
4. Put the Jack in Place
The base of the jack should be placed
on firm, level ground. The jack should
be positioned as shown in the drawing.
D060F02E-AAT
5. Raising the Car
D060E01TG-A
After inserting a wrench bar into the
wheel nut wrench, install the wrench bar
into the jack as shown in the drawing.
To raise the vehicle, turn the wheel nut
wrench clockwise. As the jack begins
to raise the vehicle, double check that
it is properly positioned and will not slip.
If the jack is on soft ground or sand,
place a board, brick, flat stone or other
object under the base of the jack to
keep it from sinking.
Raise the car high enough so that the
fully inflated spare tire can be installed.
To do this, you will need more ground
clearance than is required to remove
the flat tire.
Wheel nut
!
wrench
Do not get under the car when it is
supported by the jack! This is very
Wrench bar
dangerous as the vehicle could fall
D060F01TG-A
and cause serious injury or death.
No one should stay in the car while
the jack is being used.
WARNING: