Chicco Baby Hug Kit Instructions For Use Manual page 8

INSTRUCTIONS FOR USE
IMPORTANT WARNING
WARNING! RETAIN FOR FUTURE REFER-
ENCE.
WARNING: BEFORE USE, REMOVE
AND DISPOSE OF ALL PLASTIC
BAGS AND PACKAGING MATERIALS
AND KEEP THEM OUT OF REACH OF
CHILDREN.
Components
A - Tray
B - Rigid crotch strap
C - Arms (a-b)
D - Cover
TRAY ASSEMBLY
1. Put together rigid crotch strap B and
tray A, as shown in figure 1.
2. Insert arm A in the corresponding
through hole A found on the tray un-
til you hear an engagement click. Re-
peat this operation for arm B (Fig. 2).
3. To mount the tray on the Baby Hug,
first put the seat into the highchair po-
sition (Fig. 3).
4. Remove the toybar from the seat (Fig. 4).
5. Turn the joints towards the front of
the highchair, pressing the button on
the joint, as shown in figure 5.
6. Install the tray in the designated
housings until you hear an engage-
ment click, as shown in figure 6.
7. To remove the tray, press the two
buttons located on the inside of the
joints (Fig. 7).
WARNING: The tray must be used in
the horizontal position only when Baby
Hug is in reclined position (Fig. 8).
WARNING: After removing the tray, en-
sure that the joints are turned to the back
of the highchair, then install the toybar.
WARNING: When not in use, keep the
tray out of reach of children.
TIPS FOR CLEANING AND MAINTE-
NANCE
Cleaning and maintenance operations
must be performed exclusively by an
adult.
Wipe the plastic parts clean with a soft
damp cloth. To prevent the formation of
rust, always dry metal parts if they have
come into contact with water.
COVER
9. Fit cover D on the upper edge of the
Baby Hug backrest (Fig. 9).
10. Insert the shoulder straps and the
crotch strap in the designated holes
found on the cover (Fig. 10).
11. Finally, ensure that the elastic on the
outside perimeter of the cover ad-
heres to the seat structure (Fig. 11).
MAINTENANCE AND WASHING
Wash the cover by hand in cold water.
30° C 30° C
8