Honda 2008 Accord Owner's Manual page 340

Main Menu
HOLDING CLIPS
4.
Driver's side
To change the bulb, start the
engine, turn the steering wheel all
the way to the right, then turn off
the engine.
5. Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
Table Of Contents
ELECTRICAL CONNECTOR
6. Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
7. Remove the bulb from the fog
light assembly by turning it one-
quarter turn counterclockwise.
2008 Accord Sedan
8. Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
9. Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
10. Turn on the fog lights to test the
new bulb.
TAB
11.
Passenger's side
Reinstall the under cover and put
the three fasteners back in place.
Driver's side
Reinstall the inner fender. Make
sure it is installed under the edge
of the front bumper.
Reinstall the holding clips, and
push in its head of each clip.
Lights
337