Advertisement
Release date: 09.12.17
DIAGRAM 1 code CF0044UNUN61
1. Please identify the location of the original vehicle
OBD2 port (www.paser.it/firewall/location) and
then remove the connector from its housing;
2. Please connect the male OBD2 plug to the original
OBD2 socket (1);
3. Connect to a wire ignition
4. Please connect the Firewall OBD2 module to multi-
way connectors of the OBD2 harness of the kit;
5. Please connect the harness OBD2 socket of the kit
in the same place where it was connected to the
OEM plug.
The unit supplied with remote control follows this procedure for the activation / deactivation of Firewall. The remote control has 2
buttons, please refer to the diagram below:
BUTTON PRESS
A 1
B 2
Warning!
When Firewall is off (OFF) you can set it so that every turning on of the ignition, the unit emits 5 beeps: this setting allows the user
to know when OBD protection is OFF.
To set this mode, please connect the BLACK wire to an ignition positive.
DIAGRAM 2 code CF0044UNUN41
1. Please identify the location of the original vehicle
OBD2 port (www.paser.it/firewall/location) and
then remove the connector from its housing;
2. Please connect the male OBD2 plug to the original
OBD2 socket (1);
3. Connect to a wire ignition
4. Please connect the Firewall OBD2 module to multi-
way connectors of the OBD2 harness of the kit;
5. Please connect the harness OBD2 socket of the kit
in the same place where it was connected to the
OEM plug.
The version supplied as ignition configuration, it's a stand alone module and allows the Firewall OBD2 managing by a sequence of 3 consecutive car ignition
activations. The procedure is the following:
CONTROL PANEL TURNING ON
3
3
Warning!
When Firewall is off (OFF) at every turning on of the ignition, the unit emits 5 beeps: this allows the user to know the OBD protection is OFF.
Also on this setting, it is possible to combine a remote control.
INSTALLATION MANUAL
FIRWALL CONNECTIONS WITH REMOTE CONTROL (STAND ALONE MODE)
INSTALLATION
HOW IT WORKS?
BUZZER
FIREWALL STATUS
2 BEEP
OFF
1 BEEP
ON
FIREWALL CONNECTION WITH VEHICLE KEY (STAND ALONE ON / OFF MODE)
INSTALLATION
BUZZER
FIREWALL STATUS
2 BEEPS
1 BEEP
FIREWALL
FIREWALL OBD2
SOCKET
FIREWALL LED
GREEN
RED
FIREWALL OBD2
SOCKET
HOW IT WORKS?
FIREWALL LED
OFF
ON
2 / 4
OBD2 READING
POSSIBLE
NOT POSSIBLE
OBD2 READING
GREEN
POSSIBLE
RED
NOT POSSIBLE
rev 1.0 17
30 m
INCLUDED
A
B
Advertisement
