Paser Firewall OBD2 Installation Manual

Release date: 09.12.17
Thank you for choosing a Paser product.
Firewall OBD2 represents the return of Paser in the world of car alarms.
Faced with a deep experience in the field of cars and CAN-bus technology alarms, Paser merges the two knowledge and introduces to the car alarms market a
new weapon against increasingly sophisticated theft systems.
Through vehicles OBD2 port in fact, it is possible to code new keys so to defuse the alarm.
Paser suggests FIREWALL OBD2 to remedy the above drawback.
The module in question allows you to create a defence to the OBD2 port, so that in the unfortunate event that someone try to program a new key to the vehi-
cle, the system will deceive the programming device, consequently preventing all communications with the vehicle.
On default, the kit consists of the following parts:

1 Firewall OBD2 electronic unit;

1 installation manual;

1 warranty card

1 plastic screwdriver to make all settings
based on the versions and not included in default kit, you need:

1 Plug and Play harness (please see compatibility codes on the site www.paser.it/firewall/)

1 two-channels remote control (in stand alone mode with remote control)
Firewall has different working modes.
Default kit is set as stand alone controlled by remote control (not supplied) or wire.
Default kit has the wire input (BLACK wire) set to GND polarity, this means that, when connected to GND, the wire in object activates Firewall OBD2 unit.
Installation is very easy and completely plug and play.
You need to locate the OBD2 port of the vehicle (in case suggestions are needed, please refer to www.paser.it/firewall/).
Then you have to connect in series to the original OBD2 connector, the harness supplied in the kit and to engage the OBD2 socket of the harness in place of the
original OBD2 one.
The information provided in this manual are purely for information purposes can be subject to change without notice. At the time of publication, the infor-
mation is correct and reliable. However Paser can not be held responsible for any consequences arising from errors or omissions in this manual. Paser reserves
to itself the right to improve / modify the product or manual without the obligation to notify users.
FIREWALL
INSTALLATION MANUAL
INTRODUCTION
KIT COMPOSITION
DEFAULT SETTING
INSTALLATION
1 / 4
rev 1.0 17
30 m