Page 1
Package content: M6 set screws (2 pcs) M3 Machine Screws (4 pcs) Box Lid M10 nuts (reused from antenna) (Coax cable not included) TX15 Tapping Screw with Washer (Only applicable for type -1 and -2) Top section Bottom section N095F-Set Clamp Mount 1"-14TPI base, 4-way MWM mount Stainless Ø30-Ø100mm...
Page 2
Installation Guide This is a guide only and does not form any contract or warranty 1: Tighten the M6 set screws (2 pcs) with 2: Assemble the middle and bottom 3-5Nm recommended torque. antenna sections with 20-25 Nm (Use loctite on the set screws for extreme cases - Not supplied) recommended torque DETAIL A...