Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Elecro Engineering Escalade Welded
Summary of Contents for Elecro Engineering Escalade Welded
- Page 1 Escalade Welded Heat Exchanger Installation & Operating Manual...
- Page 2 www.elecro.co.uk...
-
Page 3: Important Notes
Important Notes! Congratulations on purchasing your new Elecro Escalade Welded Heat Exchanger. Manufactured in the UK to exacting standards, using the highest quality materials. To ensure exceptional performance and reliability please take a moment to read these instructions. Your new heat exchanger must be installed and operated as specified. -
Page 4: Specification
Specification Transfer values 30-kW 11.7 40-kW 16.1 75-kW 17.8 ΔT = Temperature difference between Primary (Hot) and Secondary (Pool) To calculate BTU multiply kW x 3412 kW x 3412 = BTU Output Note: Maximum primary operating temperature is 400ºC Dimensions (mm) - Standard Escalade Heat Exchanger Fig 2. - Page 5 Vertical Installation POOL FILTER BOILER PUMP Fig 3. Horizontal installation POOL PUMP BOILER HEAT EXCHANGER FILTER PUMP Fig 4. www.elecro.co.uk...
- Page 6 Wall mounting: Fig 5. Your heat exchanger should be connected to the two independent water circuits as follows: 1. Connection to Water Filtration Circuit (Secondary) The heat exchanger should be plumbed inline, after the filtration pump and filter and before any water treatment equipment. It should be fed with clean water.
- Page 7 2. Connection to Heating or Cooling Circuit (Primary) The heat exchanger should be connected directly to the primary heating circuit i.e. boiler, via the 1” BSP male connectors, see diagram below. NOTE: The circulation pump of the primary circuit should be controlled by a thermostat, which should be connected via the filtration pump to allow heating only when the filtration pump is running.
- Page 8 Guarantee Your Escalade welded heat exchanger is guaranteed for two years from the date of purchase against faulty workmanship and materials. ELECRO ENGINEERING LTD will replace or repair, at it’s discretion, any faulty units or components returned to the company for inspection.
-
Page 9: Rohs Compliance Statement
RoHS compliance statement Elecro Engineering Limited certify that our Heater Exchanger range complies in accordance with RoHS Directive 2002/95/EC on the restriction of hazardous substances. Waste of Electrical / Electronic Equipment This product complies with EU directive 2002/96/EC Do Not dispose of this product as unsorted municipal waste. - Page 10 11 Gunnels Wood Park Stevenage Hertfordshire SG1 2BH United Kingdom | f: | e: +44 (0) 1438 749 474 +44 (0) 1438 361 329 info@elecro.co.uk www.elecro.co.uk © Copyright 2015 Z-INS-HE-WHE...
Need help?
Do you have a question about the Escalade Welded and is the answer not in the manual?
Questions and answers