Page 1
Instruction manual Hot and cold water electrically heated high-pressure cleaners Electra 24 Electra 36 Electra 48 Electra 72 Electra 96 Please read and conform to the safety instructions before use! Keep the instructions in a safe place for later use and pass them on to any future user.
Page 2
Technical Data Technical data Electra 24 Electra 36 Electra 48 Electra 72 Operating Pressure 30 - 180 bar 30 – 180 bar 30 – 200 bar 30 – 200 bar Water output 10 l/minute 10l/minute 13 l/minute 13 l/minute Water tank level cut-out...
Page 3
Trip shunt The trip shunt device is fitted to the heater circuit breakers and on sensing that elements are too hot, will switch off the circuit breaker’s and cut supply to heater contactors. The trip shunt is controlled by a thermostat, normally open contact. This thermostat is set in the factory. This is a safety device and setting it higher will NOT make hotter water.
Need help?
Do you have a question about the Electra 24 and is the answer not in the manual?
Questions and answers